DeWalt D28710 Service Manual download pdf (Page 31)

ENGLISH

• Do not use cutting ﬂ uids. These ﬂ uids could

ignite or cause electrical shock.

• Check that the workpiece is properly supported.

• Use the cutting discs recommended by the

manufacturer only.

• The max. allowable speed of the cutting disc must

always be equal to or greater than the no-load

speed of the tool speciﬁ ed on the nameplate.

• Do not use circular saw blades or any other

toothed blades with this tool. Serious injury may

result.

• Do not use cutting discs that do not conform to

the dimensions stated in the technical data.

• Ensure that the abrasive cutting disc is correctly

ﬁ tted and tightened before use.

• Read the operating instructions supplied by the

wheel manufacturer.

• Let the tool run at no-load in a safe position for

at least 30 seconds. If there is a considerable

vibration or if any other defect occurs, stop the

tool and check it to determine the cause.

• Do not use cutting discs for side grinding.

• Do not cut concrete, brick, tile or ceramic materials.

• Do not cut wood, plastic or synthetic materials.

• Do not cut cast-iron materials.

• Never cut magnesium materials.

• Do not cut electrically live material.

• Use this tool in a well-ventilated area. Do not

operate the tool near ﬂ ammable liquids, gases or

dust. Sparks or hot chips from cutting or arcing

motor brushes may ignite combustible materials.

• Regularly clear the ventilation slots when working

in dusty conditions. If it should become necessary

to clean the slots, remember to unplug the tool

ﬁ rst.

• Always store cutting discs well-protected and in

a dry place, out of reach of children.

• Faults in the machine, including guards or cutting

discs, should be reported as soon as they are

discovered.

• Only use chop saw wheel of a

a max. thickness of 3.1 mm and

a max. diameter of 355 mm.

• Warning! Use of this tool

can generate dust containing

chemicals known to cause cancer, birth defects

or other reproductive harm.

Use appropriate respiratory protection.

• Always secure the workpiece properly before

cutting operation. Workpieces longer than 1.0m

shall be supported by suitable additional table,

buck or roller table.

• Consider that the wheel continues to rotate after

the machine is switched off.

• To prevent loss of control always ﬁ x the machine

to a bench using screw-clamps or bolts of

sufﬁ cient length and strength.

The following factors are of inﬂ uence to noise

production:

– the material to be cut.

– the type of the cutting disc.

– the feed force.

WARNING: Take appropriate measures

for the protection of hearing.

Residual Risks

• The following risks are inherent to the use of

these machines:

– Injuries caused by touching the rotating parts.

– Injuries caused by disruption of the cutting

disc.

• These risks are most evident:

– Within the range of operation.

– Within the range of the rotating machine parts.

• In spite of the application of the relevant safety

regulations and the implementation of safety

devices, certain residual risks cannot be avoided.

These are:

– Impairment of hearing.

– Risk of accidents caused by the uncovered

parts of the rotating cutting disc.

– Risk of injury when changing the disc.

– Risk of squeezing fingers when opening the

guards.

Markings on Tool

The following pictograms are shown on the tool:

Read instruction manual before use.

Wear ear protection.

Wear eye protection.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 135 136

DeWalt D28710 Service Manual Page 31

Comments to this Manuals

DeWalt D28710 Service Manual Page 31

Comments to this Manuals

Related products and manuals for Power tools DeWalt D28710