DeWalt DW077 Service Manual download pdf (Page 45)

ENGLISH

Vertical transfer feature (fig. J1 & J2)

The alignment ribs (31) help locating the position of

the up laser beam (32) over a position mark on the

floor.

• Mark a crossline on the floor.

• Place the tool over the centre of the crossline,

aligning the ribs with the floor markings.

• Transfer the centre of the crossline using the up

laser beam.

Remember: This feature works only on flat surfaces

and can only be used as a rough position

transferring aid. For a more accurate transfer of

position marks, we recommend to use a dedicated

DEWALT laser pointer.

Out-of-level alert

The out-of-level alert activates automatically 8 seconds

after the leveling procedure has been completed.

Once the out-of-level alert is activated, the tool

monitors its level position continuously.

Depending on the registered level of deviation the

tool will respond to level errors as follows:

– Deviations < 2 mm over 10 m: a level error is

automatically corrected without notifying.

– Deviations 2 - 20 mm over 10 m: a level error is

automatically corrected. The laser head

temporarily stops rotating and the laser beam

starts flashing to indicate that the tool re-adjusts

to level position.

– Deviations > 20 mm over 10 m: a level error leads

to interruption of the tool’s operation. The laser

head stops rotating and the laser beam goes off.

A rapidly beeping audio signal is produced and

the on/off indicator flashes simultaneously.

To resume the operation:

• Switch the tool off. Check the balance and set-

up and re-adjust if required before switching

the tool on again.

Tool aids (fig. K1 - K4)

Several aids have been supplied that might be

helpful while operating the tool.

Remote control (fig. K1)

The remote control allows a manual intervention of

the self-leveling feature when slope adjustment is

required. The maximum slope angle corresponds to

the self-leveling range of the tool.

The remote control also allows you to activate the

laser line and control the laser head from distances

up to 30 m radius.

Laser enhancement glasses (fig. K2)

The red lens glasses improve the visibility of the laser

beam under bright light conditions or over long

distances. Providing best results indoors, the lens

filters out ambient light and intensifies the projected

dot or line. The glasses do not keep the laser beam

from entering the eyes.

Never look into the laser beam directly

with these glasses.

DE0730 Target card (fig. K3)

The target card locates and marks the laser beam

as the beam crosses the card, thus enhancing the

visibility of the projected line. The laser beam passes

through the red plastic surface and is reflected by

the reflective rear side of the card. Supporting easy

use during plumb and level adjustment, the card is

marked with inch and metric scales, and has magnets

at the top to hold it to ceiling track or steel studs.

Wall mount (fig. K4)

The wall mount may also be used as a base to

provide extra stability for the tool.

Optional accessories

Consult your dealer for further information on the

appropriate accessories.

These are:

– DE0772 Digital laser detector

– DE0734 Grade rod

– DE0735 Tripod

– DE0736 Tripod

Battery packs

Voltage NiCd NiMH

9.6 DE9061 DE9036

12 DE9071/DE9075 DE9037

14.4 DE9091/DE9092 DE9038

18 DE9095/DE9096 DE9039

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 167 168

Comments to this Manuals

No comments

DeWalt DW077 Service Manual Page 45

Comments to this Manuals

Related products and manuals for Measuring, testing & control DeWalt DW077