DeWalt DW006 Instruction Manual download pdf (Page 6)

English

extension to make up the total length, be sure each individual

extension contains at least the minimum wire size.

Recommended Minimum Wire Size for Extension Cords

Total Length of Cord

25 ft. 50 ft. 75 ft. 100 ft. 125 ft. 150 ft. 175 ft.

7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m 53.3 m

Wire Size AWG

18 18 16 16 14 14 12

• Do not place any object on top of charger or place the charger

on a soft surface that might block the ventilation slots and

result in excessive internal heat. Place the charger in a position

away from any heat source. The charger is ventilated through slots

in the top and the bottom of the housing.

• Do not operate charger with damaged cord or plug — have

them replaced immediately.

• Do not operate charger if it has received a sharp blow, been

dropped, or otherwise damaged in any way. Take it to an

authorized service center.

• Do not disassemble charger; take it to an authorized service

center when service or repair is required. Incorrect reassembly

may result in a risk of electric shock, electrocution or fire.

• Disconnect the charger from the outlet before attempting any

cleaning. This will reduce the risk of electric shock. Removing

the battery pack will not reduce this risk.

• NEVER attempt to connect 2 chargers together.

• The charger is designed to operate on standard household

electrical power (120 Volts). Do not attempt to use it on any

other voltage. This does not apply to the vehicular charger.

Using Automatic Tune-Up™ Mode

The automatic Tune-Up™ Mode equalizes or balances the individual

cells in the battery pack allowing it to function at peak capacity. Battery

packs should be tuned up weekly or after 10 charge/discharge cycles

or whenever the pack no longer delivers the same amount of work. To

• Before using charger, read all instructions and cautionary markings

on charger, battery pack, and product using battery pack.

DANGER: 120 volts are present at charging terminals. Do not probe

with conductive objects. Electric shock or electrocution may result.

WARNING: Do not allow any liquid to get inside charger. Electric

shock may result.

CAUTION: To reduce the risk of injury, charge only D

WALT nickel

cadmium rechargeable batteries. Other types of batteries may burst

causing personal injury and damage.

CAUTION: Under certain conditions, with the charger plugged in to

the power supply, the exposed charging contacts inside the charger

can be shorted by foreign material. Foreign materials of a conductive

nature such as, but not limited to, steel wool, aluminum foil, or any

buildup of metallic particles should be kept away from charger cavities.

Always unplug the charger from the power supply when there is no

battery pack in the cavity. Unplug charger before attempting to clean.

• DO NOT attempt to charge the battery pack with any chargers

other than the ones in this manual. The charger and battery pack

are specifically designed to work together.

• These chargers are not intended for any uses other than

charging D

WALT rechargeable batteries. Any other uses may

result in risk of fire, electric shock or electrocution.

• Do not expose charger to rain or snow.

• Pull by plug rather than cord when disconnecting charger. This

will reduce risk of damage to electric plug and cord.

• Make sure that cord is located so that it will not be stepped

on, tripped over, or otherwise subjected to damage or stress.

• Do not use an extension cord unless it is absolutely

necessary. Use of improper extension cord could result in risk of

fire, electric shock, or electrocution.

• An extension cord must have adequate wire size (AWG or

American Wire Gauge) for safety. The smaller the gauge number

of the wire, the greater the capacity of the cable, that is 16 gauge

has more capacity than 18 gauge. When using more than one

1 2 3 4 5 6 7 8 9 10 11 ... 36 37

Comments to this Manuals

No comments

DeWalt DW006 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools DeWalt DW006