DeWalt DW006 Instruction Manual download pdf (Page 5)

English

Important Safety Instructions for

Battery Packs

Your tool uses a 24.0 Volt DEWALT battery pack. When ordering

replacement battery packs, be sure to include catalog number and

voltage.

The battery pack is not fully charged out of the carton. Before using the

battery pack and charger, read the safety instructions below. Consult

the chart on the back cover of this manual for compatibility of chargers

and battery packs. Then follow charging procedures outlined.

READ ALL INSTRUCTIONS

• Do not incinerate the battery pack even if it is severely

damaged or is completely worn out. The battery pack can

explode in a fire.

• A small leakage of liquid from the battery pack cells may occur

under extreme usage or temperature conditions. This does not

indicate a failure. However, if the outer seal is broken and this

leakage gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If battery liquid gets into your eyes, flush them with clean water

for a minimum of 10 minutes and seek immediate medical

attention. (Medical note: The liquid is 25-35% solution of

potassium hydroxide.)

• Charge the battery packs only in D

WALT chargers.

• DO NOT splash or immerse in water or other liquids.

• Do not store or use the tool and battery pack in locations

where the temperature may reach or exceed 105°F (such as

outside sheds or metal buildings in summer).

DANGER: Never attempt to open the battery pack for any reason.

If battery pack case is cracked or damaged, do not insert into charger.

Electric shock or electrocution may result. Damaged battery packs

should be returned to service center for recycling.

NOTE: Battery storage and carrying caps are

provided for use whenever the battery is out of the tool or

charger. Remove cap before placing battery in charger

or tool.

WARNING: Do not store or carry battery so that

metal objects can contact exposed battery terminals. For example,

do not place battery in aprons, pockets, tool boxes, product kit boxes,

drawers, etc. with loose nails, screws, keys, etc. without battery cap.

Without cap in place, battery could short circuit causing fire or burns

or damage to battery.

CAUTION: Battery pack must be securely attached to tool. If battery

pack is detached, personal injury may result.

The RBRC™ Seal

The RBRC™ (Rechargeable Battery Recycling

Corporation) Seal on the nickel-cadmium battery (or

battery pack) indicates that the costs to recycle the

battery (or battery pack) at the end of its useful life have

already been paid by D

EWALT. In some areas, it is illegal

to place spent nickel-cadmium batteries in the trash or

municipal solid waste stream and the RBRC program provides an

environmentally conscious alternative.

RBRC™ in cooperation with D

EWALT and other battery users, has

established programs in the United States to facilitate the collection of

spent nickel-cadmium batteries. Help protect our environment and

conserve natural resources by returning the spent nickel-cadmium

battery to an authorized D

EWALT service center or to your local retailer

for recycling. You may also contact your local recycling center for

information on where to drop off the spent battery.

RBRC™ is a registered trademark of the

Rechargeable Battery

Recycling Corporation.

Important Safety Instructions for Battery

Chargers

SAVE THESE INSTRUCTIONS: This manual contains important

safety instructions for battery chargers.

1 2 3 4 5 6 7 8 9 10 ... 36 37

Comments to this Manuals

No comments

DeWalt DW006 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools DeWalt DW006