DeWalt DW325PL Use and Care Manual download pdf (Page 11)

The fastener depth control adjustment feature provides control of

the nail drive depth from flush with or just above the work surface

to shallow or deep countersink.

Rotate depth control adjustment wheel (G) to give the desired depth

of drive.



The integrated rafter hook (C) can be rotated to either side of the tool

to accommodate left- or right-handed users.

NOTE: The rafter hook can not be removed.



WARNING: Read the section titled Important Safety Instructions

at the beginning of this manual. Always wear eye and ear protection

when operating this tool. Keep the nailer pointed away from yourself

and others. For safe operation, complete the following procedures

and checks before each use of the nailer.

When operating tools at temperatures below freezing, complete

preparation procedures outlined above and follow the directions

below.

1. Make sure compressor tanks have been properly drained prior

to use. Always drain the compressor tanks at least once daily

while using the nailer. This is especially important in cold weather

because any moisture in the air in the tanks will condense in the

cold temperature.

2. Keep the tool as warm as possible prior to use.

3. Put 5 to 10 drops of D

WALT Pneumatic Tool Oil or winter weight

pneumatic oil containing ethylene glycol in the end cap.

4. Lower air pressure to 80 psi or less.

5. Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings.

6. Turn pressure up to operating level (not to exceed 120 psi) and

use tool as normal.

7. Re-lubricate with D

WALT Pneumatic Tool Oil or winter weight

pneumatic oil containing ethylene glycol in the end cap at least

twice a day or after 4 hours of use.



Tool should operate normally. However, keep tool out of direct sunlight

as excessive heat can damage bumpers, o-rings and other rubber

parts.



WARNING: Disconnect air line from tool and remove fasteners

from magazine before making adjustments or personal injury may

result.



ACTION Lubricate tool with 5-10 drops of D

WALT Pneumatic

Tool Oil

WHY Prevents failure of o-rings

HOW Insert drops into air fitting on end cap of tool

ACTION Drain compressor tanks and hoses daily

WHY Prevents accumulation of moisture in compressor and

nailer

HOW Open petcocks or other drain valves on compressor

tanks. Allow any accumulated water to drain from

hoses

English

9R208191_DW325PL_DW325PT_DEWALT, FRAMING NAILER(LPF).indd 9 11/14/14 3:06 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Comments to this Manuals

No comments

DeWalt DW325PL Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Nail Gun DeWalt DW325PL