DeWalt DW325PL Use and Care Manual download pdf (Page 9)

3. Wear proper eye, hearing and respiratory protection.

 4.Removeallfastenersfromthemagazine.

5. Check for smooth and proper operation of contact trip and

pusher assemblies. Do not use tool if either assembly is not

functioning properly. NEVER use a tool that has the contact trip

restrained in the up position.

 6.Check air supply. Ensure that air pressure does not exceed

recommended operating limits, refer to Tool Specifications.

7. Connect air hose.

8. Check for audible leaks around valves and gaskets. Never use a

tool that leaks or has damaged parts.

WARNING: To reduce the risk of personal injury, disconnect tool

from air supply before performing maintenance, clearing a jammed

fastener, leaving work area, moving tool to another location or

handing the tool to another person.



WARNING: Always wear proper eye [ANSI Z87.1 (CAN/CSA

Z94.3)]andhearingprotection[ANSIS12.6(S3.19)]whenoperating

this tool.

WARNING: Keep fingers AWAY from trigger when not driving

fasteners to avoid accidental firing. NEVER carry tool with finger on

trigger. In contact mode tool will fire a fastener if safety is bumped

while trigger is depressed.

Sequential Trip: Sequential trip requires the operator to hold the

contact tip against the work surface before pulling the trigger. This

makes accurate fastener placement easier. The sequential trip allows

exact fastener placement without the possibility of driving a second

fastener on recoil, as described under Contact Trip. The sequential

trip tool has a positive safety advantage because it will not accidentally

drive a second fastener if the tool is contacted against the work or

anything else while the operator is holding the trigger pulled.

Contract Trip: The common operating procedure on contact trip

tools is for the operator to contact the work surface to actuate

the trip mechanism while keeping the trigger pulled, thus driving

a fastener each time the work is contacted. This will allow rapid

fastener placement on many jobs, such as sheathing, decking

and pallet assembly. All pneumatic tools are subject to recoil when

driving fasteners. The tool may bounce, releasing the trip, and if

unintentionally allowed to recontact the work surface with the trigger

still actuated (finger still holding the trigger pulled) an unwanted

second fastener will be driven.

TO CHANGE OPERATING MODES (FIG. 1, 4–6)

WARNING: Disconnect air line from tool and remove fasteners

from magazine before making adjustments or personal injury may

result.

WARNING: Be aware that once the locking pin is removed, the

trigger is converted to a selectable trigger, enabling either sequential

trip or contract trip operating modes.

WARNING: Always know the tool operating mode before

connecting to an air supply and/or using the tool.

The tool is initially locked in the sequential

FIG. 4

trip operating mode. In order to enable the

mode selection feature the mode locking

pin (H) must be removed.

NOTE: The mode locking pin is for

shipping purposes only. Discard pin after

removing.

English

9R208191_DW325PL_DW325PT_DEWALT, FRAMING NAILER(LPF).indd 7 11/14/14 3:06 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

DeWalt DW325PL Use and Care Manual Page 9

Comments to this Manuals

Related products and manuals for Nail Gun DeWalt DW325PL