DeWalt DCD735-XE Instruction Manual download pdf (Page 13)

FUEL GAUGE BATTERY PACKS (FIG. 7)

Some D

EWALT battery packs include a fuel gauge which consists of three green LED

lights that indicate the level of charge remaining in the battery pack.

To actuate the fuel gauge, press and hold the fuel gauge button (L). A combination

of the three green LED lights will illuminate designating the level of charge left. When

the level of charge in the battery is below the usable limit, the fuel gauge will not

illuminate and the battery will need to be recharged.

NOTE: The fuel gauge is only an indication

FIG. 7

of the charge left on the battery pack. It

does not indicate tool functionality and is

subject to variation based on product

components, temperature and end-user

application.

For more information regarding fuel gauge

battery packs, please contact Stanley

Black & Decker, 82 Taryn Drive, Epping,

VIC 3076 Australia or call 1800 444 224 or (NZ) 0800 339 258.

Drilling (Fig. 8)

NOTICE: If drilling thin material, use a wood “back-up” block to prevent damage to the

material.

1. Select the desired speed/torque range using the gear shifter to match the speed

and torque to the planned operation. Turn the collar (C) to the drill symbol.

2. Use sharp drill bits only. For MASONRY, such as brick, cement, cinder block, etc.,

use carbide-tipped bits rated for percussion drilling.

3. Always apply pressure in a straight

DRILLING

FIG. 8

line with the bit. Use enough pressure

to keep drill biting, but do not push

hard enough to stall the motor or

deflect the bit.

4. Hold tool firmly with both hands to

control the twisting action of the drill. If

model is not equipped with side handle,

grip drill with one hand on the handle

and one hand on the battery pack.

WARNING: Drill may stall if overloaded causing a sudden twist. Always expect the

stall. Grip the drill firmly to control the twisting action and avoid injury.

5. IF DRILL STALLS, it is usually because it is being overloaded or improperly used.

RELEASE TRIGGER IMMEDIATELY, remove drill bit from work, and determine

cause of stalling. DO NOT DEPRESS TRIGGER ON AND OFF IN AN ATTEMPT TO

START A STALLED DRILL — THIS CAN DAMAGE THE DRILL.

6. To minimize stalling or breaking through the material, reduce pressure on drill and

ease the bit through the last fractional part of the hole.

. Keep the motor running when pulling the bit back out of a drilled hole. This will

help prevent jamming.

HAMMERDRILLINGSCREWDRIVING

FIG. 9

FIG. 10

Screwdriving (Fig. 9)

1. Select the desired speed/torque range using the gear shifter to match the speed

and torque to the planned operation.

NOTE: Use the lowest torque setting required to seat the fastener at the desired

depth. The lower the number, the lower the torque output.

2. Turn the torque adjustment collar (C) to the desired position.

3. Insert the desired fastener accessory into the chuck as you would any drill bit.

4. Make some practice runs in scrap or on unseen areas of the workpiece to

determine the proper position of the torque adjustment collar.

5. Always start with lower torque settings, then advance to higher torque settings to

avoid damage to the workpiece or fastener.

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

DeWalt DCD735-XE Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCD735-XE