DeWalt DCD735-XE Instruction Manual download pdf (Page 12)

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury, place the forward/

reverse button in the lock-off position or turn tool off and disconnect battery pack

before making any adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

Keyless Single Sleeve Chuck (Fig. 3–5)

WARNING: Do not attempt to tighten drill bits (or any other accessory) by gripping

the front part of the chuck and turning the tool on. Damage to the chuck and personal

injury may result. Always lock off trigger switch and disconnect tool from power

source when changing acces sories.

WARNING: Always ensure the bit is secure before starting the tool. A loose bit

may eject from tool causing possible personal injury.

Your tool features a keyless chuck (F) with one rotating sleeve for one-handed

operation of the chuck. To insert a drill bit or other accessory, follow these steps.

1. Turn tool off and disconnect tool from power source.

2. Grasp the black sleeve of the chuck with one hand and use the other hand to

secure the tool. Rotate the sleeve counterclockwise far enough to accept the

desired accessory.

3. Insert the accessory about 19 mm (3/4") into the chuck and tighten securely by

rotating the chuck sleeve clockwise with one hand while holding the tool with

the other. Your tool is equipped with an automatic spindle lock mechanism. This

allows you to open and close the chuck with one hand.

Be sure to tighten chuck with one hand on the chuck sleeve and one hand holding the

tool for maximum tightness.

To release the accessory, repeat steps 1 and 2 above.

Belt Hook and Bit Clip (Fig. 2)

WARNING: To reduce the risk of serious personal injury, place the forward/

reverse button in the lock-off position or turn tool off and disconnect battery pack

before making any adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

WARNING: To reduce the risk of serious personal injury, DO NOT suspend tool

overhead or suspend objects from the belt hook. ONLY hang tool’s belt hook from a

work belt.

WARNING: To reduce the risk of serious personal injury, ensure the screw

holding the belt hook is secure.

IMPORTANT: When attaching or replacing the belt hook or bit clip, use only the screw

(H) that is provided. Be sure to securely tighten the screw.

The belt hook (G) and bit clip (I) can be be attached to either side of the tool using

only the screw (H) provided, to accommodate left- or right- handed users. If the hook

or bit clip is not desired at all, it can be removed from the tool.

To move belt hook or bit clip, remove the screw (H) that holds it in place then

reassemble on the opposite side. Be sure to securely tighten the screw.

OPERATION

WARNING: To reduce the risk of serious personal injury, place the forward/

reverse button in the lock-off position or turn tool off and disconnect battery pack

before making any adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

Installing and Removing the Battery Pack (Fig. 6)

NOTE: For best results, make sure your battery pack is fully charged.

To install the battery pack (K) into the tool handle, align the battery pack with the

rails inside the tool’s handle and slide it into the handle until the battery pack is firmly

seated in the tool and ensure that it does not disengage.

To remove the battery pack from the tool, press the release button (J) and firmly pull

the battery pack out of the tool handle. Insert it into the charger as described in the

charger section of this manual.

FIG. 6

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

DeWalt DCD735-XE Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCD735-XE