DeWalt DXCMLA3706056 Use and Care Manual Page 14
- Page / 88
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
14
English
SPRAY
GUN
AIR
TOOL
DRAIN
LEGS
FILTER /
MOISTURE
TRAP
DIRT
LEGS
DRAIN
VALVES
DRAIN
VALVE
LUBRICATOR
REGULATOR
GLOBE VALVE /
AIR DISCHARGE
VALVE
MAIN DISTRIBUTION AIR LINES
Slope pipe in direction of air flow.
Water condensate flows along
bottom of pipe to drain legs,
preventing it from entering feeder
lines.
REGULATOR
BALL
FILTER
FLEXIBLE
COUPLING
DRAIN
VALVE
TYPICAL
COMPRESSED AIR
DISTRIBUTION
SYSTEM
AIR FLOW
AIR FLOW
FEEDER LINES SLOPE
WITH AIR FLOW
AIR USAGE
LINES
AIR
COMPRESSOR
FILTER /
MOISTURE
TRAP
FOR BEST PERFORMANCE
the distance between the
compressor and the
moisture trap should be as
long as possible
RISK OF BURSTING. ALWAYS USE
METAL PIPING AND FITTINGS.
DRAIN
VALVES
5 MICRON
FILTER
.01 MICRON
FILTER
How to Use Your Unit (Fig 3)
How to Stop:
Set the Auto/Off switch to “Off”.
Before Starting
WARNING: Do not operate this unit until you read this instruction
manual for safety, operation and maintenance instructions.
Break-in Procedure
NOTICE: Risk of property damage. Serious damage may result if
the following break-in instructions are not closely followed.
This procedure is required before the air compressor is put into
service and when the check valve or a complete compressor pump
has been replaced.
1. Make sure the Auto/Off switch is in the “Off” position.
2. Check oil level in pump. See Oil paragraph in the Maintenance
section for instructions.
3. Recheck all wiring. Make sure wires are secure at all terminals
connections. Make sure all contacts move freely and are not
obstructed.
4. Open the drain valve (counterclockwise) fully to permit air to
escape and prevent air pressure build up in the air tank during
the break-in period.
5. Move the Auto/Off switch to “Auto” position. The compressor
will start.
6. Run the compressor for 30 minutes. Make sure the drain valve
and all air lines are open so there is only a minimal air pressure
build-up in tank.
NOTE: After about 30 minutes, If the unit does not operate
properly, SHUT DOWN IMMEDIATELY, and contact
Product Service.
7. Check all air line fittings and connections/piping for air leaks
by applying a soap solution. Correct if necessary. NOTE: Minor
leaks can cause the air compressor to overwork, resulting in
premature breakdown or inadequate performance.
8. Check for excessive vibration. Readjust or shim air compressor
- DXCMLA3706056 1
- Air Compressor 2
- Pump Specifications 2
- Specifications 2
- Hot Surfaces 3
- Important Safety Instructions 3
- SAVE THESE INSTRUCTIONS 4
- Know Your Air Compressor 9
- FEATURES 9
- INSTALLATION 10
- Assembly (Fig. 1) 10
- Compatibility 11
- Location 11
- Wiring Instructions 12
- Grounding Instructions 12
- Air Distribution System 13
- How to Use Your Unit (Fig 3) 14
- Shut-down (Fig. 1) 15
- MAINTENANCE 16
- Maintenance Chart 16
- Checking Air Filter (Fig. 1) 17
- Draining Air Tank (Fig. 3) 17
- Compressor Pump Oil (Fig. 4) 18
- Belt Replacement 18
- Adjusting Belt Tension 19
- Downward Force 19
- Troubleshooting Guide 24
- Troubleshooting Codes 24
- GLOSSARY 27
- Français 30
- AVERTISSEMENT : 30
- CONSERVER CES DIRECTIVES 30
- CONSERVER CES CONSIGNES 36
- POUR UTILISATION ULTÉRIEURE 36
- CARACTÉRISTIQUES (Fig. 1) 36
- Assemblage (Fig. 1) 37
- Compatibilité 38
- Emplacement 38
- Directives de câblage 39
- Directives de mise à la terre 40
- SYSTÈME DE DISTRIBUTION 41
- D'AIR TYPIQUE 41
- Arrêt (Fig. 1) 43
- Programme d’entretien 44
- Remplacement de la courroie 47
- (Fig. 1) 47
- Force descendante 48
- Glossaire 53
- Guide de dépannage 54
- Codes de dépannage 55
- Superficies calientes 59
- GUARDE ESTAS INSTRUCCIONES 60
- PELIGRO: RIESGO DE EXPLOSIÓN 61
- Elementos y accesorios: 62
- Neumáticos: 62
- CARACTERÍSTICAS (Fig. 1) 66
- SAVE THESE INSTRUCTIONS FOR 66
- FUTURE USE 66
- Instalación 67
- Ensamblaje (Fig. 1) 67
- Lubricación y aceite 68
- Compatibilidad 68
- Anclaje del compresor de aire 69
- SISTEMA TÍPICO DE 71
- DISTRIBUCIÓN DE AIRE 71
- Cómo detenerla 72
- Antes de ponerlo en marcha 72
- Procedimiento de asentamiento 72
- Apagado (Fig. 1) 73
- MANTENIMIENTO 74
- Tabla de mantenimiento 74
- REEMPLAZO (Fig. 1) 75
- (Fig. 4) 76
- Correa - Reemplazo 77
- Fuerza hacia abajo 78
- Polea y volante – Alineación 78
- GLOSARIO 83
- EWALT Industrial Tool Co 88
Related products and manuals for Air compressors DeWalt DXCMLA3706056
(7 pages)© 2020, manymanuals.com. All rights reserved. | 2.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals