DeWalt DXCMLA3706056 Use and Care Manual download pdf (Page 11)

English

1. Ensure regulated pressure gauge reads 0 psi.

2. Apply sealant tape to hose threads.

3. Assemble hose to air outlet (F). IMPORTANT: Do not assemble

splitters directly to the air outlet (F).

NOTE: Assembling quick connect bodies (L) to air outlet (F)

and quick connect plugs to hose ends make connecting and

disconnecting hoses simple and easy. Quick connect bodies

and plugs are available for purchase from your local dealer or

authorized service center.

DISCONNECTING HOSES

WARNING: Risk of unsafe operation. Firmly grasp hose in hand

when installing or disconnecting to prevent hose whip.

1. Ensure regulated pressure gauge reads 0 psi.

2. Remove hose from air outlet (F).

Lubrication and Oil

AIR COMPRESSOR

The air compressor pump was filled WITH oil at the manufacturer.

Check air compressor pump oil level before operating unit. See

Compressor Pump Oil under Maintenance.

Compatibility

Air tools and accessories that are run off the compressor must be

compatible with petroleum based products. If you suspect that a

material is not compatible with petroleum products, an air line filter

for removal of moisture and oil vapor in compressed air is required.

NOTE: Always use an air line filter to remove moisture and oil vapor

when spraying paint.

Location

• Locatetheaircompressorinaclean,dry,andwellventilated

area.

• Locatedtheaircompressoratleast12” (30.5cm) away from

the wall or other obstructions that will interfere with the flow of

air.

• Locatetheaircompressorasclosetothemainpowersupply

as possible to avoid using long lengths of electrical wiring.

NOTE: Long lengths of electrical wiring could cause power loss

to the motor.

• Theairfiltermustbekeptclearofobstructionswhichcould

reduce air flow to the air compressor.

HUMID AREAS

In frequently humid areas, moisture may form in the pump and

produce sludge in the oil, causing running parts to wear out

prematurely. Excessive moisture is especially likely to occur if

the unit is located in an unheated area that is subject to large

temperature changes. Two signs of excessive humidity are external

condensation on the pump when it cools down and a “milky”

appearance in compressor oil. You may be able to prevent

moisture from forming in the pump by increasing ventilation or

operating for longer intervals.

NOISE CONSIDERATIONS

Consult local officials for information regarding acceptable

noise levels in your area. To reduce excessive noise, use

vibration mounts or silencers, relocate the unit or construct total

enclosures or baffle walls. Contact a D

WALT service center or

call 1-888-895

4549 for assistance.

Anchoring of the Air Compressor

WARNING: Risk of bursting. Excessive vibration can weaken the

air tank and cause an explosion. The compressor must be properly

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

Comments to this Manuals

No comments

DeWalt DXCMLA3706056 Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Air compressors DeWalt DXCMLA3706056