DeWalt DCS393-XE Instruction Manual

DCS391-XE, DCS393-XE 18 V CORDLESS 165 mm (6-1/2") CIRCULAR SAWINSTRUCTION MANUAL

8SAVE THESE INSTRUCTIONS FOR FUTURE USECOMPONENTSWARNING: Never modify the power tool or any part of it. Damage or personal injury could result.Please

9Trigger Switch (Fig. 3)WARNING: This tool has no provision to lock the trigger switch in the ON position and should never be locked ON by any other m

10HPOSPINDLEBLADEOPHFIG. 4bNOTE: Never engage the blade lock while saw is running, or engage in an effort to stop the tool. Never turn the saw on whil

11LOWER BLADE GUARDWARNING: The lower blade guard is a safety feature which reduces the risk of serious personal injury. Never use the saw if the lowe

12 C. Overreaching or operating the saw with poor body control (out of balance), can result in twisting the blade. D. Changing hand grip or bo

13 2. Retract the lower blade guard. Place the saw on blade FIG. 8Q side. 3. Loosen bevel adjustment knob. Place a square against the blade and shoe

14CuttingPlace the wider portion of the saw shoe on that part of the workpiece which is solidly supported, not on the section that will fall off when

6. Start the motor and gradually lower the saw until its shoe rests flat on the material to be cut. Advance saw along the cutting line until cut is

DCS391-XE, DCS393-XE 18 V CORDLESS 165 mm (6-1/2") CIRCULAR SAW A. Trigger switch lock-off button B. Trigger switch C. Battery pack D. De

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia (MAR11) Part No. N111074 DCS

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch

3 • Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised DEWALT Service Centre in

4 • Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leave

5respiratory protection appropriate for the dust exposure. Direct particles away from face and body.WARNING: Always wear proper personal hearing prote

6 • If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse

7Charging Procedure (Fig. 1) 1. Plug the charger into an appropriate outlet before inserting the battery pack. 2. Insert the battery pack (C) into