DeWalt D25901 Instruction Manual download pdf (Page 28)

English

FIG. 2

D25901

FIG. 3

D25901

1. Clean and grease the chisel shank.

CAUTION: Do not apply lubricant to the machine.

2. Insert the chisel shank into the tool holder/sleeve (E). Press and

turn the chisel slightly until the sleeve snaps into position.

3. Pull on the chisel to check if it is properly locked. The hammering

function requires the chisel to be able to move axially several

centimeters when locked in the tool holder.

4. To remove a chisel, pull back the tool holder/sleeve (E) and pull

the chisel out of the tool holder.

Inserting and Removing 19 mm Hex

Accessories

CAUTION: To reduce the risk of tool damage, only use 3/4" (19 mm)

hex shank accessories with the D25941.

D25941 (FIG. 4, 5)

This machine uses chisels with a 19 mm hex shank (refer to the inset

in Figure 5 for a cross-section of a chisel shank).

1. Clean and grease the chisel shank.

CAUTION: Do not apply lubricant to the machine.

19 mm

FIG. 4

D25941

FIG. 5

D25941

2. Pull back the tool holder/sleeve (E), align the groove (G) with the

yellow marker (H) and insert the chisel shank into the tool holder.

Release the locking sleeve.

3. Pull on the chisel to check if it is properly locked. The hammering

function requires the chisel to be able to move axially several

centimetres when locked in the tool holder.

4. To remove a chisel, pull back the tool holder/sleeve (E) and pull

the chisel out of the tool holder.

Indexing the Chisel Position (Fig. 6)

The chisel can be indexed and locked into 12 different positions.

1. Insert the chisel as described above.

2. Rotate the chisel position collar (D) in the direction of the arrow

until the chisel is in the desired position.

1 2 ... 23 24 25 26 27 28 29 30 31 32

No comments

DeWalt D25901 Instruction Manual Page 28