DeWalt DC733-XE Instruction Manual

DC733-XECORDLESS COMPACT 10 mm (3/8" ) DRILL/DRIVER INSTRUCTION MANUAL

8OPERATIONWARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or

9Inserting and Removing Bits PFIG. 4(Fig. 1, 4) 1. Open the chuck by turning the sleeve (P) counterclockwise and insert the bit shank. 2. Place the

10 • Keep the motor running when pulling the bit back out of a drilled hole. This will help prevent jamming.PRIOR TO OPERATION 1. Make sure your ba

11CHARGER CLEANING INSTRUCTIONSWARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from t

12

13

Battery Output Chargers/Charge Time Nominal 240 Volts 12 Volts X Indicates that the battery pack is not compatible with that specific char

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may res

3Extension CordsCAUTION: Use only extension cords that are approved by the country’s Electrical Authority. Before using extension cords, inspect them

4NOTE: Battery storage and carrying caps are provided for use whenever the battery is out of the tool or charger. Remove cap before placing

5open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte is composed of a mixture of liquid organi

6 • Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive

7HOT/COLD PACK DELAYSome chargers have a Hot/Cold Pack Delay feature: when the charger detects a battery that is hot, it automatically starts a Hot Pa