DeWalt D25501 Instruction Manual download pdf (Page 32)

English

• crystalline silica from bricks and cement and other masonry

products, and

• arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you

do this type of work. To reduce your exposure to these chemicals:

work in a well ventilated area, and work with approved safety

equipment, such as those dust masks that are specially designed to

filter out microscopic particles.

• Avoid prolonged contact with dust from power sanding,

sawing, grinding, drilling, and other construction activities.

Wear protective clothing and wash exposed areas with

soap and water. Allowing dust to get into your mouth, eyes, or

lay on the skin may promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/or disburse dust,

which may cause serious and permanent respiratory or other injury.

Always use NIOSH/OSHA approved respiratory protection appropriate

for the dust exposure. Direct particles away from face and body.

WARNING: ALWAYS USE SAFETY GLASSES. Everyday

eyeglasses are NOT safety glasses. Also use face or dust mask if

cutting operation is dusty. ALL USERS AND BYSTANDERS MUST

ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:

• ANSI Z87.1 eye protection (CAN/CSA Z94.3),

• ANSI S12.6 (S3.19) hearing protection,

• NIOSH/OSHA/MSHA respiratory protection.

• The label on your tool may include the following symbols. The

symbols and their definitions are as follows:

V ................... volts A ......................amperes

Hz ................. hertz W .....................watts

min ............... minutes

or AC ..........alternating

or DC ... direct current current

................. Class I Construction or AC/DC ...alternating

.....................

(grounded) ........................or direct

................. Class II Construction current

(double insulated)

o ....................no load

…/min ..........revolutions per minute ....................... speed

BPM ............. beats per minute

n ......................rated

IPM ............... impacts per minute

........................speed

SPM ............. strokes per minute

.....................earthing

sfpm .............surface feet terminal

..................... per minute ..................... safety alert

..................... symbol

Motor

Your DEWALT tool is powered by a DEWALT-built motor. Be

sure your power supply agrees with the nameplate markings.

Voltage decrease of more than 10% will cause loss of power and

overheating. All D

EWALT tools are factory tested.

DESCRIPTION (FIG. 1)

WARNING: Never modify the power tool or any part of it. Damage

or personal injury could result.

A. Trigger switch F. Mode selector

B. Lock-on slider G. Electronic Speed and

C. Side handle impact control dial

D. Main handle H. Clamp knob

E. Active vibration control I. Rear side handle position

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

DeWalt D25501 Instruction Manual Page 32

Comments to this Manuals

Related products and manuals for Rotary hammers DeWalt D25501