DeWalt DW941 Service Manual download pdf (Page 36)

ENGLISH

34

or electrocution may result. Damaged

battery packs should be returned to

service centre for recycling.

CAUTION: When not in use, place

tool on its side on a stable surface

where it will not cause a tripping or

falling hazard. Some tools with large

battery packs will stand upright on the

battery pack but may be easily knocked

over.

SPECIFIC SAFETY INSTRUCTIONS FOR NICKEL CADMIUM

(NiCd) OR NICKEL METAL HYDRIDE (NiMH)

• Do not incinerate the battery pack even if it

is severely damaged or is completely worn

out. The battery pack can explode in a fire.

• A small leakage of liquid from the battery

pack cells may occur under extreme usage

or temperature conditions. This does not

indicate a failure.

However, if the outer seal is broken:

a. and the battery liquid gets on your skin,

immediately wash with soap and water for

several minutes.

b. and the battery liquid gets into your eyes,

flush them with clean water for a minimum

of 10 minutes and seek immediate medical

attention. (Medical note: The liquid is

25–35% solution of potassium hydroxide.)

SPECIFIC SAFETY INSTRUCTIONS FOR LITHIUM ION

(Li-Ion)

• Do not incinerate the battery pack even if it

is severely damaged or is completely worn

out. The battery pack can explode in a fire.

Toxic fumes and materials are created when

lithium ion battery packs are burned.

• If battery contents come into contact with

the skin, immediately wash area with mild

soap and water. If battery liquid gets into the

eye, rinse water over the open eye for

15 minutes or until irritation ceases. If medical

attention is needed, the battery electrolyte

is composed of a mixture of liquid organic

carbonates and lithium salts.

• Contents of opened battery cells may cause

respiratory irritation. Provide fresh air. If

symptoms persists, seek medical attention.

WARNING: Burn hazard. Battery liquid

may be flammable if exposed to spark

or flame.

Battery Cap (ﬁ g. 3)

A protective battery cap is supplied to cover the

contacts of a detached battery pack. Without the

protective cap in place, loose metal objects could

short circuit the contacts, causing a fire hazard and

damaging the battery pack.

1. Take off the protective battery cap before

placing the battery pack in the charger

or tool (fig. 3A).

2. Place the protective cap over the contacts

immediately after removing the battery pack

from the charger or tool (fig. 3B).

WARNING: Make sure the protective

battery cap is in place before storing or

carrying a detached battery pack.

Battery Pack (ﬁ g. 2)

BATTERY TYPE

The DW941 operates on 14.4 volt battery packs.

Storage Recommendations

1. The best storage place is one that is cool and

dry away from direct sunlight and excess heat

or cold. For optimum battery performance and

life, store battery packs at room temperature

when not in use.

NOTE: Li-Ion battery packs should be fully

charged when stored.

2. Long storage will not harm the battery pack or

charger. Under proper conditions, they can be

stored for up to 5 years.

Labels on Charger and Battery Pack

In addition to the pictographs used in this manual,

the labels on the charger and the battery pack show

the following pictographs:

Read instruction manual

before use.

Battery charging.

Battery charged.

Battery defective.

Hot/cold pack delay.

Do not probe with conductive objects.

Do not charge damaged battery packs.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 163 164

Comments to this Manuals

No comments