DeWalt DCH363KL Use and Care Manual download pdf (Page 12)

2. Rotate the side handle to the desired position.

3. Tighten the side handle by turning it clockwise until you are sure

the side handle won’t slip.

TO CHANGE SIDES

For right-hand users: slide the side handle clamp over the chuck,

handle at the left.

For left-hand users: slide the side handle clamp over the chuck,

handle at the right.

Depth Rod

(Fig. 2)

To adjust the depth rod (F), loosen the side handle (A) and move the

depth rod so that the distance between the end of the rod and the

end of the bit equals the desired drilling depth. When drilling with

depth rod, stop when end of rod reaches surface of material.

Switch (Fig. 2)

To turn the tool on, squeeze the trigger switch (B). To turn the tool

off, release the trigger switch. Your tool is equipped with a brake. The

chuck will stop as soon as the trigger switch is fully released.

VARIABLE SPEED SWITCH

The variable speed switch enables you to select the best speed for a

particular application. The farther you squeeze the trigger, the faster

the tool will operate. For maximum tool life, use variable speed only

for starting holes or fasteners.

NOTE: Continuous use in variable speed range is not recommended.

It may damage the switch and should be avoided.

Mode Selector (Fig. 2)

CAUTION: Never change the mode while the unit is running.

For straight drilling, rotate the mode selector (D) until the arrow points

to the drill bit symbol (H). For rotary hammer, align the arrow with the

hammer symbol (I). For chipping mode align arrow with the chipping

symbol (J).

NOTE: The mode selector (D) must be in drill, hammer or chipping

mode at all times. There are no operable positions in between.

Forward/Reverse Control Button

(Fig. 1, 3)

A forward/reverse control button (C) determines the direction and also

serves as a lock-off button.

To select forward rotation, release the trigger switch (B) and

depress the forward/reverse control button on the right side of thetool.

To select reverse, depress the forward/reverse control button on the

left side of the tool.

The center position of the control button locks the tool in the

off position. When changing the position of the control button, be

sure the trigger is released.

NOTE: The first time the tool is run after changing the direction of

rotation, you may hear a click on start up. This is normal and does

not indicate a problem.

FIG. 3

LOCKED

UNLOCKED,

REVERSE

UNLOCKED,

FORWARD

English

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Comments to this Manuals

No comments

DeWalt DCH363KL Use and Care Manual Page 12

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCH363KL