DeWalt DCF813 Service Manual download pdf (Page 31)

ENGLISH

a. Trigger switch

b. Forward/reverse button

c. Chuck collar (DCF815)

d. 1/4" (6.35 mm) hex quick-release chuck

(DCF815)

e. Battery release button

f. Battery pack

g. Worklight

h. Main handle

i. Anvil (DCF813)

j. Hog ring (DCF813)

INTENDED USE

The impact driver and impact wrench are designed

for professional impact fastening applications. The

impact function makes this tool particularly useful for

driving fasteners in wood, metal and concrete.

DO NOT use under wet conditions or in presence of

flammable liquids or gases.

This impact driver and impact wrench are

professional power tools. DO NOT let children come

into contact with the tool. Supervision is required

when inexperienced operators use this tool.

• This product is not intended for use by persons

(including children) suffering from diminished

physical, sensory or mental abilities; lack of

experience, knowledge or skills unless they are

supervised by a person responsible for their

safety. Children should never be left alone with

this product.

Electrical Safety

The electric motor has been designed for one

voltage only. Always check that the battery pack

voltage corresponds to the voltage on the rating

plate. Also make sure that the voltage of your

charger corresponds to that of your mains.

Your DEWALT charger is double insulated

in accordance with EN 60335; therefore

no earth wire is required.

If the supply cord is damaged, it must be replaced

by a specially prepared cord available through the

DEWALT service organisation.

Mains Plug Replacement

(U.K. & Ireland Only)

If a new mains plug needs to be fitted:

• Safely dispose of the old plug.

• Connect the brown lead to the live terminal in

the plug.

• Connect the blue lead to the neutral terminal.

WARNING: No connection is to be

made to the earth terminal.

Follow the fitting instructions supplied with good

quality plugs. Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless

absolutely necessary. Use an approved extension

cable suitable for the power input of your charger

(see Technical Data). The minimum conductor size

is 1.5 mm

; the maximum length is 30 m.

When using a cable reel, always unwind the cable

completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and

adjustment, always remove the battery

pack. Always switch off the tool before

inserting or removing the battery pack.

WARNING: Use only DEWALT battery

packs and chargers.

Inserting and Removing the

Battery Pack from the Tool (ﬁ g. 3)

WARNING: To reduce the risk

of serious personal injury, place

the forward/reverse button in

the lock-off position or turn tool

off and disconnect battery pack

before making any adjustments or

removing/installing attachments or

accessories.

NOTE: Make sure your battery pack (f) is fully

charged.

TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE

1. Align the battery pack with the rails inside the

handle.

2. Slide it firmly into place until you hear the lock

snap into place.

TO REMOVE THE BATTERY PACK FROM THE TOOL

1. Press the release button (e) and firmly pull the

battery pack out of the tool handle.

2. Insert battery pack into the charger as

described in the charger section of this manual.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

DeWalt DCF813 Service Manual Page 31

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCF813