DeWalt DCD710-XE Instruction Manual Page 1

DCD710-XE10 mm (3/8") 10.8 V CORDLESS ADJUSTABLE CLUTCH DRILL/DRIVERINSTRUCTION MANUAL

8To select reverse, depress the forward/reverse control button on the left side of the tool. The center position of the control button locks the tool

9Keyless Single Sleeve Chuck FIG. 5(Fig. 5)Your tool features a keyless chuck with one rotating sleeve for one-handed operation of the chuck.

10WARNING: The drill may stall if overloaded causing a sudden twist. Always expect the stall. Grip the drill firmly with both hands to control the twi

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia 1800 444 224 (Aust) or 0800 339 258

1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 0800 339258 (NZ). SAFETY INSTRUCTIONS FOR POW

2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch

3 • Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised DEWALT Service Centre in

4a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should b

5CAUTION: Burn hazard. To reduce the risk of injury, charge only DEWALT rechargeable batteries. Other types of batteries may burst causing personal in

6Indicator Light OperationCharge Indicators Some chargers are designed to detect certain problems that can arise with battery packs. Problems are indi

7Storage Recommendations 1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold. 2. For long stora