DeWalt DC234-XE Instruction Manual

DC232-XE, DC233-XE, DC234-XEHEAVY-DUTY 36V CORDLESS ROTARY HAMMER INSTRUCTION MANUAL

8NOTE: The mode selector (D) must be in drill, hammer or chipping (DC233, DC234-XE only) mode at all times. There are no operable positions in between

9SDS Chuck (Fig. 4)WARNING: Turn off tool and remove battery pack from tool before changing accessories or making any adjustments.CAUTION: Do not use

10 6. Use a slow speed to start the hole and accelerate by squeezing the trigger harder when the hole is deep enough to drill without the bit skippin

11product to sound mechanical and/or electrical condition. Normal wear parts are not covered in this service. Carbon brushes worn more then 50% will b

DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 • 20 Fletcher Road, Mooroolbark, VIC 3138 Australia(AUG06) Form No. 576

1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 526 2556 (NZ).GENERAL SAFETY INSTRUCTIONSW

2f. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or

3 • Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. Keep a firm grip on the tool at all times. Do not attem

4 • Do not expose charger to rain or snow. • Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plu

5 • Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk

6The RBRC™ SealThe RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the lithium ion battery (or battery pack) indicates that the costs to r

7Important Charging Notes 1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 18°