DCL030-XE, DCL040-XECORDLESS LED WORKLIGHTINSTRUCTION MANUAL
8WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic material
Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(
1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to
2f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the ris
3Electrical SafetyThe electric motor has been designed for one voltage range only. Always check that the power supply corresponds to the voltage on th
4 • If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse
5 • Pull by the plug rather than the cord when disconnecting the charger. This will reduce the risk of damage to the electric plug and cord. • Make su
6Charge Indicators This charger is designed to detect certain problems that can arise. Problems are indicated by the red light flashing at a fast rate
7NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be recharged before use. SAVE THESE INSTRUCTION
Comments to this Manuals