DeWalt DW077 Instruction Manual download pdf (Page 12)

English

Installing and Removing the

Battery Pack

NOTE: Make sure your battery pack is fully

charged before you install it.

INSTALLING THE BATTERY PACK

1. Rotate the battery adapter plate (A) so that the

applicable cut out for 9.6, 12, 14.4 volt pack or

the 18 volt pack is aligned with the battery

contacts facing the inside of the cut out.

2. Slide the battery pack in firmly until you hear the battery pack

lock in place.

REMOVING THE BATTERY PACK

1. Push the battery in slightly, press the release buttons, and firmly

pull the battery pack out of the receptacle.

2. The battery ejector pin (D) will aid in removing the pack.

3. To recharge the battery pack, insert it into the charger as

described in the charger section of this manual.

Control Panel

The laser is controled by the power button (E), the speed/rotation

button (F), the scan mode button (G), and two arrows (H and I). The

arrows control the movement of the laser head left and right or up

and down depending on whether the laser is being used in the

level mode or the plumb mode. Three indicator lights are on the

control panel, power (J), X-axis leveling (K), and Y-axis leveling (L).

TURNING THE LASER ON

1. Insert the fully charged battery pack through the proper cut out in

battery adapter plate. Be sure that the battery is firmly engaged.

2. Gently press the ON/OFF button (E) to power the laser on. The

laser diode will turn on and the power LED Light (J) will illumi-

nate. If the laser is out of level, the X-axis and/or Y-axis leveling

lights (K and L) will flash until the laser is level. Press the

speed/rotation button (F) to make the head rotate.

NOTE: The head will only rotate momentarily if the laser is leveling.

The head will begin or resume rotation once the laser is level.

TURNING THE LASER OFF

Gently press the ON/OFF button to turn the laser off. The power

LED Light will no longer be illuminated.

ROTATION SPEEDS

The rotary head speed can be adjusted by pressing the speed/rota-

tion button. The head speed will cycle through 4 speeds and stop,

then repeat the sequence as the speed/rotation button is pressed.

REMEMBER:

Slow speed = Bright Beam Fast Speed = Solid Beam

Using the Laser on a Tripod

1. Position the tripod securely and set it to the desired height.

2. Make sure that the top of the tripod is roughly level. the laser will

self-level only if the top of the tripod is within ± 5˚ of level. If the

J K L

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Comments to this Manuals

No comments

DeWalt DW077 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Laser levels DeWalt DW077