DeWalt DCF886-XE Instruction Manual

DCF886-XE 18V 6.35 mm (1/4") BRUSHLESS CORDLESS IMPACT DRIVERINSTRUCTION MANUAL

8Belt Hook and Bit Clip (Fig. 2)WARNING: To reduce the risk of serious personal injury, turn the tool off and disconnect the battery pack before makin

9To remove the battery pack from the tool, press the release button (E) and firmly pull the battery pack out of the tool handle. Insert it into the ch

10The center position of the control button locks the tool in the OFF position. When changing the position of the control button, be sure the trigger

11CleaningWARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear A

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCEThe term “power tool” in the warnings refers to your mains-operated (corded) power tool or bat

3e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power too

4 • The label on your tool may include the following symbols. The symbols and their definitions are as follows:V ...volts A ...

5 • Charge the battery packs only in designated DEWALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the t

6 • When operating a charger outdoors, always provide a dry location and use an extension cord suitable for outdoor use. Use of a cord suitable for ou

7NOTE: This could also mean a problem with a charger.PROBLEM POWERLINESome chargers have a problem powerline indicator. When the charger is used with