DeWalt DW089-XE Instruction Manual

DW089-XE 3 BEAM LINE LASERINSTRUCTION MANUAL

8 5. Measure the distance between the two ceiling marks (G, H). If the measurement is greater than the values shown below, the laser must be serviced

9CHECKING 90º ACCURACY BETWEEN VERTICAL BEAMS (FIG. 9)Checking 90º accuracy requires an open floor area at least 10 m x 5 m (33' x 18'). Ref

10TroubleshootingTHE LASER DOES NOT TURN ON • Make sure batteries are installed according to (+) and (–) on the inside of the battery door. • Mak

11USING THE LASER WITH ACCESSORIES (FIG. 2, INSET)The laser is equipped with a 1/4" x 20 female thread (I) on the bottom of the unit. This thread

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia 1800 444 224 (Aust) or 0800 339 258

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2 • Position the laser securely on a level surface. Damage to the laser or serious injury could result if the laser falls. CAUTION: Use of controls or

3ELECTRICAL SAFETY • Use battery operated tool only with the specifically designed batteries. Use of any other batteries may create a risk of fire.Bat

4FIG. 2AI(+)A(–)(–)BDCEHFA, IG(+)OPERATIONTo Turn the Laser On and Off (Fig. 2)With the laser off, place it on a flat surface. This model has three ON

5OUT OF TILT RANGE INDICATOR (FIG. 3) FIG. 3>4°AVERAGEThe DW089-XE laser is designed to self-level. If the laser has been tilted so much that it ca

6CleaningExterior plastic parts may be cleaned with a damp cloth. Although these parts are solvent resistant, NEVER use solvents. Use a soft, dry clo

7 6. Adjust the height of the laser so that the center of the beam is aligned with the nearest mark (D). 7. Mark the center of the beam (E) directly