DeWalt DCD985B Use and Care Manual download pdf (Page 11)

English

A. Trigger switch H. Side handle

B. Forward/reverse control button I. Battery pack

C. Worklight J. Battery release button

D. Chuck K. Belt hook

E. Torque adjustment collar L. Bit clip

F. Mode control collar M. Screw

G. Gear shifter

Variable Speed Trigger Switch (Fig. 2)

To turn the tool on, squeeze the trigger switch (A). To turn the tool

off, release the trigger switch. Your tool is equipped with a brake. The

chuck will stop as soon as the trigger switch is fully released.

NOTE: Continuous use in variable speed range is not recommended.

It may damage the switch and should be avoided.

Side Handle (Fig. 2)

WARNING: To reduce the risk of personal injury, ALWAYS

operate the tool with the side handle properly installed. Failure to do

so may result in the side handle slipping during tool operation and

subsequent loss of control. Hold tool with both hands to maximize

control.

Side handle (H) clamps to the front of the gear case and may be rotated

360° to permit right- or left-hand use. Side handle must be tightened

sufficiently to resist the twisting action of the tool if the accessory binds

or stalls. Be sure to grip the side handle at the far end to control the tool

during a stall.

If model is not equipped with side handle, grip drill with one hand on

the handle and one hand on the battery pack.

NOTE: Side handle comes equipped on both models.

NOTE: Battery packs should not be stored completely depleted of

charge. The battery pack will need to be recharged before use.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

COMPONENTS (Fig. 2)

WARNING: Never modify the power tool or any part of it. Damage

or personal injury could result.

FIG. 2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

No comments

DeWalt DCD985B Use and Care Manual Page 11