DeWalt DXH45LP Instruction Manual download pdf (Page 7)

English

Operating Instructions

WARNING

If you do not follow these instructions exactly, a re or explosion may

result causing property damage, personal injury or loss of life.

WARNING

This appliance is hot during normal operation. Avoid physical contact.

WARNING

Do not place clothing or other cumbustible materials on this appliance.

DO NOT operate this heater if any part has been under water. Call a qualiﬁed

service technician to inspect the appliance and to replace any part of the

control system or gas control valve which has been under water.

This appliance must be installed and operated only in locations where the potential

for physical damage to the appliance is reduced to a minimum. The owner/operator

of this appliance must ensure that precautions are taken to protect the appliance

from physical damage.

LIGHTING AND SHUT‑DOWN

Lighting the Heater:

1. Before attempting to light the heater, smell all around the heater area for

gas. Be sure to smell next to the ﬂoor because LP-Gas is heavier than air and

will settle on the ﬂoor. Turn on the gas supply to the appliance and check all

ﬁttings and connections for gas leaks using a mild soap and water solution.

NEVER use a match to check for gas leaks. Should a gas leak occur, shut off

the gas supply to the appliance immediately. Wait a minimum of ﬁve minutes

before repairing the leak.

2. Use only the fuel intended for this appliance. Check the appliance rating plate

for the correct fuel information.

3. Turn off the main gas supply to the appliance. Wait ﬁve minutes.

4. Turn on the main gas supply.

5. Depress red spark ignition button repeatedly or with a lighted match held

to the burner face, depress and hold the reset button on the safety valve.

After the burner ignites, hold the reset button depressed for about one

minute or until the burner stays lit when the reset button is released.

DO NOT light the gas at the burner oriﬁce. DO NOT face heater when

attempting to light. Always stand to the side of the unit when lighting.

NOTE: In cases where long runs of gas supply lines have been installed

ahead of the appliance, it may be necessary to bleed trapped air out of

the supply lines before lighting the burner. New installations generally

require bleeding of supply lines. Wait a minimum of ﬁve minutes after

bleeding the supply lines before attempting to light the heater.

6. IMPORTANT: DO NOT attempt to adjust the main burner input using

the main gas supply valve, for this may cause the thermocouple to shut

down the burner.

Shut‑Down Instructions:

To turn the heater OFF:

1. Close the LP-Gas supply cylinder valve.

2. Observe the burner until ﬂame is extinguished.

3. Listen for closure of the safety valve.

WARNING

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

DeWalt DXH45LP Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Space heaters DeWalt DXH45LP