DeWalt DXH45LP Instruction Manual download pdf (Page 4)

English

• Do not take any action that could ignite the fuel gas. Do not operate any

electrical switches. Do not plug in or disconnect any power supply or

extension cords. Do not light matches or any other source of ame. Do not

use your telephone.

• Get everyone out of the building and away from the area immediately.

• Close all propane (LP) gas tank or cylinder fuel supply valves, or the main

fuel supply valve located at the meter if you use natural gas.

• Propane (LP) gas is heavier than air and may settle in low areas. When you

have reason to suspect a propane leak, keep out of all low areas.

• Use your neighbor’s phone and call your fuel gas supplier and your re

department. Do not re-enter the building or area.

• Stay out of the building and away from the area until declared safe by the

reghters and your fuel gas supplier.

• FINALLY, let the fuel gas service person and the reghters check for

escaped gas. Have them air out the building and area before you return.

Properly trained service people must repair any leaks, check for further

leakages, and then relight the appliance for you.

Fuel Gas Odor—Fuel Leaks

LP gas and natural gas have man‑made odorants added speciﬁcally

for detection of fuel gas leaks. If a gas leak occurs you should be able

to smell the fuel gas. Since Propane (LP) is heavier than air you should

smell for the gas odor low to the ﬂoor. ANY GAS ODOR IS YOUR SIGNAL

TO TAKE IMMEDIATE ACTION!

Odor Fade Warning

General Information

Your DXH45LP gas ﬁred infra-red heater come fully assembled, with the

exception of the wheels and wheel hardware. To install the wheels and wheel hardware:

1. Install one of the cotter pins into the hole on one end of the axle.

2. Slide one large washer, then the wheel onto the axle next to the cotter pin.

3. Slide a spacer onto the axle next to the wheel.

4. Slide the partially assembled axle through the axle support holes in the heater frame.

5. Slide the second spacer onto the axle, next to the heater frame.

6. Slide the second wheel, then large washer, onto the axle and secure with the

second cotter pin.

7. Install the rubber hub caps onto the large washers to complete the wheel assembly.

B. Each heater is equipped with a 100% safety shutoff, push button valve which

will automatically stop the ﬂow of gas in the event the heater fails to operate for

any reason. A tip over switch and an excess ﬂow check are also standard on the

model DXH45LP.

C. Before proceeding with this assembly, be sure to inspect for damages. The

freight company must be notiﬁed of any damages and request that an in

spection be made. Enerco Technical Products will send replacements for dam-

aged parts only after receiving a signed inspection report to prove the liability of

the freight company.

The heater is designed and approved for use as a construction heater in

accordance with Standard ANSI Z83.7-CSA 2.14. CHECK WITH YOUR LOCAL

FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.

For Safe Operation

A. READ THESE INSTRUCTIONS CAREFULLY. Read and follw these in‑

structions. DO NOT allow anyone who has not read these instructions to

assemble, light, adjust or operate this heater.

B. LP‑Gas IS HIGHLY FLAMMABLE. In the event of a leak, LP-Gas will accumu

late and the possibility of a ﬁre is present. LP-Gas is scented and its strong odor is

readily detectable. Never strike a match, bring any ﬂame or create an electric spark in

an enclosure when you smell LP-Gas. Ventilate the area thoroughly, move the heater

outside, and correct the source of the leak before attempting to light any appliance.

C. Always operate the heater with the LP-Gas cylinder in an upright position on a level

non-combustible surface. NEVER PLACE THE CYLINDER ON ITS SIDE WHEN

OPERATING THE HEATER.

D. DO NOT attempt to operate the heater with any gas other than that in

‑

dicated on the heater nameplate.

• Some people cannot smell the odor of the man-made chemical added

to propane (LP) or natural gas. You must determine if you can smell the

odorant in these fuel gases.

• Learn to recognize the odor of propane (LP) gas and natural gas. Local

propane (LP) gas dealers will be more than happy to give you a scratch and

sniff pamphlet. Use it to become familiar with the fuel gas odor.

• Smoking can decrease your ability to smell. Being around an odor for a

period of time can affect your sensitivity to that particular odor. Odors

present in animal connement buildings can mask fuel gas odor.

Odor Fading—No Odor Detected

WARNING

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

DeWalt DXH45LP Instruction Manual Page 4

Comments to this Manuals

Related products and manuals for Space heaters DeWalt DXH45LP