DeWalt DW735 Use and Care Manual download pdf (Page 15)

English

Troubleshooting Guide

IF THE UNIT DOES NOT RUN, CHECK TO SEE:

• if the unit is plugged in.

• if the dust shroud is properly in place.

• if the top cover is properly in place.

• if the circuit breaker needs to be reset.

IF THE MATERIAL DOES NOT FEED PROPERLY, CHECK FOR:

• excess clogging in the dust shroud.

• excess oil/debris from feed rollers.

• excessively twisted, cupped or bowed material.

• a broken drive belt.

IF CHIPS DO NOT EJECT FROM THE REAR OF THE UNIT, CHECK TO SEE:

• if the dust shroud is properly in place.

• if the dust shroud and fan are clogged or obstructed.

IF THE CIRCUIT BREAKER TRIPS:

• check for dull knives. Dull knives could cause motor overloading.

• reduce depth of cut. An overly aggressive cut could cause motor overloading.

• drop feed rate to 14ft/min. A reduction in feed rate will reduce the load on the motor and prevent breaker trips.

IF THE BRANCH (HOUSE/SHOP) CIRCUIT BREAKER TRIPS REPEATEDLY:

• unplug or turn off other devices sharing the circuit with the planer OR use the planer on another branch

circuit by itself.

• check for dull knives. Dull knives could cause motor overloading.

• reduce depth of cut. An overly aggressive cut could cause motor overloading.

• drop feed rate to 14ft/min. A reduction in feed rate will reduce the load on the motor and prevent breaker trips.

NOTE: Even under normal loading conditions, other electrical loads on the same branch circuit may cause the circuit

breaker to trip.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

No comments

DeWalt DW735 Use and Care Manual Page 15