DeWalt DW713 Instruction Manual

DW713-XE 254 mm (10") COMPOUND MITER SAWINSTRUCTION MANUALQuestions? See us on the World Wide Web at www.dewalt.com

8straight crosscut is made with the miter arm at the zero degree position. Set the miter arm at zero, hold the wood on the table and firmly against th

9Keep both feet firmly on the floor and maintain proper balance. As you move the miter arm left and right, follow it and stand slightly to the side of

10position the wood with the broad flat side on the table and the narrow edge against the fence.The two sketches in Figure 17 are for four sided objec

11FIG. 23CENTER MARK ON VERNIER SCALE ALIGNS WITH DESIRED WHOLE ANGLE ON MITER SCALE(24° RIGHT MITER)FIG. 25FIG. 241/4° VERNIER MARK ALIGNS WITH CLOSE

12INSTRUCTIONS FOR CUTTING CROWN MOLDING ANGLED BETWEEN THE FENCE AND BASE OF THE SAW FOR ALL CUTS: 1. Angle the molding so the bottom of the molding

13Right side 1. Miter right at 45°2. Save left side of cutSpecial CutsNEVER MAKE ANY CUT UNLESS THE MATERIAL IS SECURED ON THE TABLE AND AGAINST THE F

14TROUBLESHOOTING GUIDEBE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONSTROUBLE! WHAT’S WRONG? WHAT TO DOSaw will not start 1. Saw not plugged in 1.

15101010202020303030404040505050606060707070808080TABLE 1: COMPOUND MITER CUT (POSITION WOOD WITH BROAD FLAT SIDE ON THE TABLE AND THE NARROW EDGE AGA

DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 • 20 Fletcher Road, Mooroolbark, VIC 3138 Australia(NOV07) Form No.6483

1TABLE OF CONTENTSDOUBLE INSULATION ...

2Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

3 • BE SURE all blade and blade clamps are clean, recessed sides of blade clamps are against blade and arbor screw is tightened securely. Loose or im

4Electrical SafetyThe electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rati

5AccessoriesWARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this

6Bench Mounting Holes are provided in all four feet to facilitate bench mounting, as shown in Figure 2. (Two different sized holes are provided to acc

7BEVEL POINTERIf the bevel pointer does not indicate zero, loosen the screw that holds it in place and move the pointer as necessary.SUGGESTION: For a