DeWalt DW9118 Instruction Manual

DCGG57018V Grease GunPistolet graisseur 18vPistola engrasadora de 18VINSTRUCTION MANUALGUIDE D’UTILISATIONMANUAL DE INSTRUCCIONESINSTRUCTIVO DE OPERA

operation, fl ashing the red light with two fast blinks followed by a pause. This indicates the power source is out of limits.LEAVING THE BATTERY PACK

NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be recharged before use.SAVE THESE INSTRUCTIONSF

To unlock the trigger switch, press the BFIG. 4lock-off button as shown in Figure 4. Squeeze the trigger switch to turn the motor ON. Releasing the tr

ASSEMBLY AND ADJUSTMENTS WARNING: To reduce the risk of serious personal injury, turn tool off, push the lock-off button to the OFF position, and re

NOTE: The seal resembles a cup, which should open toward the top cap (F, Fig. 2) when prepared for suction and fi ller pump fi lling. 4. Reinsert the g

NOTE: Do not lock the rod into the retaining slot (O). 2. Connect the low pressure fi tting on the grease gun to the appropriate low pressure fi tting

Once the correct amount of grease has been dispensed, release the trigger and remove the coupler from the grease fi tting. If the coupler does not rele

3. Reinstall the ball (CC), the spring (DD), and then the disc (EE). 4. After all grease is cleaned from the area, reinstall the check valve plug (

• CONFIRMATION OF OWNERSHIP: In case of an insurance loss, such as fi re, fl ood or theft, your registration of ownership will serve as your proof of p

TROUBLESHOOTINGProblem Possible Cause Possible SolutionUnable to pull back rod Vacuum build up Unscrew the purge valve to release vacuum.Unable to pus

Defi nitions: Safety Guidelines The defi nitions below describe the level of severity for each signal word. Please read the manual and pay attention to

DEWALT Battery and Charger SystemsChargers/Charge Time (Minutes) – Chargeurs/Durée de charge (Minutes) – Cargadores de baterías/Tiempo de carga (Minut

f) If operating a power tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) protected supply. Use of a GFCI reduces

pack may create a risk of fi re when used with another battery pack.b) Use power tools only with specifi cally designated battery packs. Use of any ot

• crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber.Your risk from the

as battery pack may rupture causing serious personal injury. Consult the chart at the end of this manual for compatibility of batteries and chargers.

WARNING: Burn hazard. Battery liquid may be fl ammable if exposed to spark or fl ame. The RBRCTM SealThe RBRC™ (Rechargeable Battery Recycling Corp or

• When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of el

continues up to 8 hours or until the individual cells in the battery pack are equalized. The battery pack is ready for use and can be removed at any t