DeWalt DCG412 Instruction Manual download pdf (Page 14)

Accessories

It is important to choose the correct guards, backing pads and

flanges to use with grinder accessories. Refer to pages 14 and 15 for

information on choosing the correct accessories.

_,WARNING: Accessories must be rated for at least the speed

recommended on the tool warning label. Wheels and other accessories

running over their rated accessory speed may fly apart and cause

injury. Threaded accessories must have a 5/8"-11 hub. Every

unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it

does not, it may have been designed for a circular saw. Use only the

accessories shown on pages 14 and 15 of this manual Accessory

ratings must always be above tool speed as shown on tool nameplate.

Mounting Guard

MOUNTING AND REMOVING GUARD (FIG. 4}

_WARNING: To reduce the risk of serious personal injury,

turn tool off and remove the battery pack before making any

adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

_ CAUTION: Guards must be used with all grinding wheels,

cutting wheels, sanding flap discs, wire brushes, and wire

wheels. The tool may be used without a guard only when sanding

with conventional sanding discs. A Type 27 guard (intended for

use with depressed center grinding wheels [Type 27 and Type

29], sanding flap discs, wire wheels and wire cup brushes) is

available at extra cost from your local dealer or authorized service

center. Grinding and cutting with wheels other than Type 27 and

29 require different accessory guards not included with tool A

Type 1 guard is provided for use with the Type 1 wheel Mounting

instructions for accessory guards are shown below and are also

included in the accessory package.

1. Open the guard latch (K), and align the

lugs (L) on the guard with the slots on

the gear case (M). This will align the

lugs on the guard with the slots on the

gear case cover.

2. Push the guard down until the guard

lugs engage and rotate freely in the

groove on the gear case hub.

3. With the guard latch open, rotate

the guard (I) into the desired working

position. The guard body should be

positioned between the spindle and

the operator to provide maximum

operator protection.

4. Close the guard latch to secure the

guard on the gear case. You should

FIG. 4

not be able to rotate the guard by hand when the latch is closed.

Do not operate the grinder with a loose guard or the clamp lever

in open position.

5. To remove the guard, open the guard FIG.5

latch, rotate the guard so that the

arrows are aligned and pull up on the

guard.

NOTE: The guard is pre-adjusted to the

diameter of the gear case hub at the

factory. If, after a period of time, the guard

becomes loose, tighten the adjusting

screw (N) with clamp lever in the closed N

position with guard installed on the tool.

_CAUTION: Do not tighten the adjusting screw with the clamp

lever in the open position. Undetectable damage to the guard or the

mounting hub may result.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 84 85

Comments to this Manuals

No comments

DeWalt DCG412 Instruction Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCG412