DeWalt DCF813 Instruction Manual download pdf (Page 21)

FIG. 9C

FIG. 9A

FIG. 9B

FLUSH-TO CUTTING

Worklight (Fig. 9C)

The worklight (E) is located below the blade clamp (F) behind the shoe

The worklight will be activated when the trigger switch is squeezed.

NOTE: The worklight is for lighting the immediate work surface and

is not intended to be used as a flashlight.

Cutting (Fig. 9, 10–13)

WARNING: Always use eye protection. All users and bystanders

must wear eye protection that conforms to ANSI Z87.1.

WARNING: Exercise extra caution when cutting towards operator.

Always hold saw firmly with both hands while cutting.

Before cutting any type of material, be sure it is firmly anchored or

clamped to prevent slipping. Place blade lightly against work to be

cut, switch on saw motor and allow it to obtain maximum speed

before applying pressure. Whenever possible, the saw shoe must be

held firmly against the material being cut. This will prevent the saw

from jumping or vibrating and minimize blade breakage. Any cuts

which put pressure on the blade such as angle or scroll cuts increase

potential for vibration, kickback, and blade breakage.

WARNING: Use extra caution when cutting overhead and pay

particular attention to overhead wires which may be hidden from view.

Anticipate the path of falling branches and debris ahead of time.

WARNING: Inspect work site for hidden gas pipes, water pipes,

or electrical wires before making blind or plunge cuts. Failure to do

so may result in explosion, property damage, electric shock, and/or

serious personal injury.

FLUSH-TO CUTTING (FIG. 9B, 10)

The compact design of the saw motor

FIG. 10

housing and spindle housing permits

extremely close cutting to floors, corners

and other difficult areas. The blade should

be inserted upside-down to assist in flush-

cutting (Fig.9B, 10).

POCKET/PLUNGE CUTTING – WOOD

ONLY (FIG. 11)

The initial step in pocket cutting is to

measure the surface area to be cut

and mark clearly with a pencil, chalk or

scriber. Use the appropriate blade for the

application. The blade should be longer

than 3-1/2" (89 mm) and should extend

past the shoe and the thickness of the workpiece during the cut. A 4"

(102 mm) blade is recommended for best performance. Insert blade

into the blade clamp.

English

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 69 70

Comments to this Manuals

No comments

DeWalt DCF813 Instruction Manual Page 21

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCF813