9
ENGLISH
Conductor size (mm
2
) Cable rating (Amperes)
0.75 6
1.00 10
1.50 15
2.50 20
4.00 25
Cable length (m)
7.5 15 25 30 45 60
Voltage Amperes Cable rating (Amperes)
115 0 - 2.0 6 6 6 6 6 10
2.1 - 3.4 6 6 6 6 15 15
3.5 - 5.0 6 6 10 15 20 20
5.1 - 7.0 10 10 15 20 20 25
7.1 - 12.0 15 15 20 25 25 -
12.1 - 20.0 20 20 25 - - -
230 0 - 2.0 6 6 6 6 6 6
2.1 - 3.4 6 6 6 6 6 6
3.5 - 5.0 6 6 6 6 10 15
5.1 - 7.0 10 10 10 10 15 15
7.1 - 12.0 15 15 15 15 20 20
12.1 - 20.0 20 20 20 20 25 -
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Fitting regular sanding sheets (fig. B1 - B3)
• Soften the sanding sheet by rubbing its non-
abrasive side over the edge of a worktop.
• Release both sanding sheet clamp knobs (4).
• Hold the sanding pad (3) with one hand and align
the dust extraction holes (5).
• Slide the sanding sheet under the sanding sheet
clamp (4).
• Engage the corresponding sanding paper clamp
knob (4).
• Stretch the sanding paper firmly over the sanding
pad (3) and repeat for the other clamp.
Dust extraction (fig. C)
Since woodworking with a sander
produces dust, always install a dustbag
designed in compliance with the
applicable directives regarding dust
emission.
Do not use a dustbag or vacuum
extractor without proper spark protection
when sanding metal.
The tool is supplied with an adapter for connecting a
dustbag or a vacuum extractor.
• Fit the dust extraction adaptor (6) onto the outlet
(2) as shown.
• Attach the dustbag (7) by aligning the open-
ended slots (8) with the notches (9) and fitting the
bag onto the adaptor (6).
• Turn the assembly clockwise to lock it in position.
• Alternatively, connect the tool to a vacuum
extractor using the adaptor (6).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Make sure all materials to be sanded are well
secured.
• Apply only a gentle pressure to the workpiece.
Excessive pressure does not improve the
sanding effect, but only results in an increased
load on the machine and causes the abrasive to
tear.
• Avoid overloading.
Do not sand magnesium!
Switching on and off (fig. A)
• To switch the tool on, set the on/off switch to
position I.
• To switch the tool off, set the on/off switch to
position O.
Comments to this Manuals