8
ENGLISH
d Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
e Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tools operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
f Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g Use the power tool, accessories and tool bits
etc., in accordance with these instructions
and in the manner intended for the particular
type of power tool, taking into account the
working conditions and the work to be
performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a qualified
repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional safety instructions for sanders
Take special care when sanding some
woods (e.g. beech, oak) and metal which
may produce toxic dust. Wear a dust
mask specifically designed for protection
against toxic dust and fumes and ensure
that persons within or entering the work
area are also protected.
• Use this tool in a well-ventilated area when
sanding ferrous metals. Do not operate the tool
near flammable liquids, gases or dust. Sparks or
hot particles from sanding or arcing motor
brushes may ignite combustible materials.
Sanding paint
Observe the applicable regulations for sanding paint.
Pay special attention to the following:
1 Whenever possible, use a vacuum extractor for
dust collection.
2 Take special care when sanding paint which is
possibly lead based:
• Do not let children or pregnant women enter the
work area.
• All persons entering the work area should wear a
mask specially designed for protection against
lead paint dust and fumes.
• Do not eat, drink or smoke in the work area.
3 Dispose of dust particles and any other removal
debris safely.
Description (fig. A)
Your palm grip sander D26441 has been designed
for sanding of wood, metal and plastics in a
professional environment.
1 On/off switch
2 Dust extraction outlet
3 Sanding pad
4 Sanding sheet clamp knob
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your DEWALT tool is double insulated in
accordance with EN 60745; therefore no
earth wire is required.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
(14 pages)
(54 pages)
(88 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals