DeWalt DW078 Instruction Manual download pdf (Page 12)

English

REMOTE CONTROL: POWER BUTTON

Press the remote control power button (G) to put the laser unit into

Sleep Mode. In Sleep Mode all laser unit functions shut off except

for a periodic blink from the power LED (D) on the control panel of

the laser unit. Press the remote control power button again to “wake

up” the laser unit.

NOTE: To completely power the laser unit off, the power button

on the control panel of the laser unit must be pressed. The laser

unit will also automatically power off if it is left in Sleep Mode for

8 hours.

REMOTE CONTROL: MANUAL MODE BUTTON

To activate Manual Mode, press and hold the remote control

manual mode button (H) for 3 seconds. Manual Mode must be

activated to use manual sloping. (Refer to Using Manual Slope

Mode for a complete description of this function.)

To re-engage full self-leveling, press and hold the manual button

again for 3 seconds.

Using Manual Slope Mode:

The DW078 Manual Slope Mode allows the self-leveling

function to be disabled in one axis (direction) so that the

laser can be sloped in that axis. The other axis will continue

to self-level, ensuring that the laser beam is only sloping in

the expected direction.

Entering and exiting Manual Slope Mode:

• To activate manual sloping mode, press and hold the

remote control manual mode button (H) for 3 seconds.

• To re-engage full self-leveling, press and hold the

manual button again for 3 seconds.

Setting the Slope Direction:

• When Manual Slope Mode is activated, the unit

automatically engages Manual Y Mode. This allows the

operator to slope the laser in the direction of the Y-axis,

as indicated by the “gunsights” on the roll cage.

In certain situations, it may be desirable to slope the

laser in the X-axis. The direction of Manual Slope Mode

can be changed back and forth between the Y- and

X-axes as follows:

• Immediately (within 5 seconds) after entering Manual

Slope Mode, press and hold the remote control right

arrow button to activate Manual X Mode.

• The unit can be changed back to Manual Y Mode

by immediately pressing and holding the remote

control left arrow button.

• To change the direction of Manual Slope Mode at a

later time, re-engage full self-leveling, then activate

Manual Slope Mode again and go through the axis

selection procedure outlined above.

The X and Y LED indicator lights on the laser unit control panel

(Fig. 3, E, F) will indicate the manual slope direction that

is selected. The manually controlled axis is identified by a

turned-off LED, and the self-leveling axis is identified by a

lighted LED.

Setting the Amount of Slope:

Once Manual Slope Mode is activated, the amount

of slope can be manually adjusted using either of the

following methods:

• Use the remote control up and down arrow buttons

(Fig. 3, I) to tilt the laser rotor head up and down.

• The entire laser unit can be tipped up and down by

setting it on a sloped surface. Make sure the laser unit is

positioned so the direction of manual sloping is lined up in

the same direction as the sloped surface.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Comments to this Manuals

No comments

DeWalt DW078 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Laser levels DeWalt DW078