DeWalt DW746 User Manual download pdf (Page 7)

English

Adjusting saw level: Your mobile base can be leveled

to the floor by raising or lowing the adjusting feet.

Move the saw to the location you wish to use it.

Disengage the castor assembly. If the saw rocks on

the floor, the adjusting foot not touching the floor can

be lowered or the foot in contact can be raised to

compensate.

Adjusting stabilizing legs: If you have stabilizing legs

in place, for the slide table accessory, it will be neces-

sary to adjust them for use with the mobile base.

STEP 11. Place saw on base. Use extreme caution when

lifting. Use two people to lift saw. Insure that castor

assembly is in disengaged position (see Operation

section). Carefully lift the saw and place it over the car-

riage bolts, through the round holes in the feet, and

onto the base.

STEP 12. Secure base to saw (Fig. 9).

You will need: 4 - 8mm (28mm OD) flat washers

4 - 8mm lock washers

4 - 8mm nuts

Insure that the square portion of the 8 x 40mm car-

riage bolts are still engaged to the square holes in the

base (try spinning the bolt with your fingers.) Add a

flat washer, lock washer, and nut to each bolt and

tighten securely. Roll the saw over and off the card-

board spacers.

Operation

• To move your saw, depress the foot pedal to engage

the castor assembly (Fig. 10A). Saw can now be eas-

ily be moved to a new location.

• Disengage castor assembly by raising the foot pedal

(Fig. 10B), allowing the adjusting feet to contact the

floor surface.

• Always disengage the castor assembly and make sure

the mobile base is in full contact with the floor before

you operate your DW746 Woodworker’s Table Saw.

FIG. 10A FIG. 10B

STEP 1. Remove one leg at a time. Do not remove both

legs at the same time. With the table saw installed on

the mobile base, remove the hardware holding a sta-

bilizing leg in place. Remove the leg and reverse it so

that the slots with the ID mark between them are now

down. Place leg back over the M8x55 hardware.

Secure leg in place with removed hardware. Tighten

loosely. Repeat for the second stabilizing leg.

STEP 2. Adjust stabilizing leg height by sliding them

down until they contact the floor. Tighten hardware

securely.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

DeWalt DW746 User Manual Page 7

Comments to this Manuals

Related products and manuals for Circular saws DeWalt DW746