DeWalt DCS370 User Manual Page 1

INSTRUCTION MANUALTo learn more about BIESEMEYER MANUFACTURINGvisit our web site at: www.biesemeyer.com.For Parts, Service, Warranty or other assistan

5. When the fence locking handle (B) Fig. 28, is pushedto the down position, the fence assembly (C) should becompletely clamped to the guide tube. If

9. The distance the fence is positioned away from the sawblade is indicated by the witness line (S) located in cursor (E),Fig. 31. To calibrate the cu

Delta will repair or replace, at its expense and at its option, any new Delta machine,machine part, or machine accessory which in normaluse has proven

INTRODUCTIONThe BIESEMEYER® T-SQUARE® Commercial fence system includes the fence assembly, front rail, rear railand front guide tube along with the mo

1. T-Square® Fence2. Support Leg (2)3. Leveling Foot (2)4. 3/8-16 Hex Nut (2)5. #8 x 5/8” Pan HD Screw (12)6. #10-32 X 3/8” RND HD Screw (2)7. Flat Wa

CONSTRUCTING EXTENSION TABLEASSEMBLY (DELTA SAWS ONLY)FOR ALL OTHER SAWS, PROCEEDDIRECTLY TO PAGE 7, STEP 1.DISCONNECT THE SAW FROMTHE POWER SOURCE!F

REAR RAIL FOR DELTA SAWSNOTE: Do not use template to set rear rail.3. Align the two non-countersunk holes in the rear rail with thetwo holes in the r

6. Lay the table upside down on the floor or on a bench.7. Position the table leg (I) to the closed in corner of the extensiontable (J) as shown in Fi

ASSEMBLY (FOR ALL OTHER SAWS)DISCONNECT THE SAW FROM THE POWERSOURCE!ASSEMBLE FRONT RAIL1. Raise saw blade (A) Fig. 15. Place a straight edge (B)again

IMPORTANT: If your saw fence system will be usedwith a mobile base underneath the saw base and tablelegs, the position of the legs will have to be cha

ASSEMBLY (FOR ALL SAWS)1. Attach knob (A) Fig. 23 to locking handle (B). Knob isscrewed onto threads of locking handle.2. Align fence side (C) Fig. 24