DeWalt DCS391 Service Manual

DCS391

8ENGLISH WARNING: We recommend the use of a residual current device with a residual current rating of 30mA or less.Residual RisksThe following risks

9ENGLISH • Do not operate charger with damaged cord or plug — have them replaced immediately. • Do not operate charger if it has received a sharp bl

10ENGLISHImportant Safety Instructions for All Battery PacksWhen ordering replacement battery packs, be sure to include the catalog number and voltage

11ENGLISHmake sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit.The in

12ENGLISHDescription (fi g. 1, 4, 6) WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. a. Trigger swit

13ENGLISHTO REMOVE THE BATTERY PACK FROM THE TOOL 1. Press the battery release button (m) and firmly pull the battery pack out of the tool handle.

14ENGLISH 3. Check the direction of rotation of the blade. 4. Thread on the blade clamping screw (h) by hand to hold the washer in position. Turn an

15ENGLISH • Use the kerf indicator (i) to follow the line drawn on the workpiece. The kerf indicator lines up with the left side of the saw blade wh

16ENGLISHVISUALLY EXAMINE CARBIDE BLADES BEFORE USE. REPLACE IF DAMAGED.Consult your dealer for further information on the appropriate accessories.Pro

17

BCopyright DEWALTEnglish (original instructions) 4

Belgique etLuxembourg Belgiëen LuxemburgDEWALT - Belgium BVBAEgide Walschaertsstraat 162800 Mechelen Tel: NL 32 15 47 37 63Tel: FR 32 15 47 37 64Fax

1fcebgkilhamFigure 1Figure 2cdamjnbcmv

2Figure 4Figure 5Figure 3qjfedo

3sklfrhgFigure 7Figure 8tldeFigure 9uFigure 6po

4ENGLISHreduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vi

5ENGLISHHorst GrossmannVice President EngineeringDEWALT, Richard-Klinger-Straße 11,D-65510, Idstein, Germany15.11.2014 WARNING: To reduce the risk o

6ENGLISHtool that cannot be controlled with the switch is dangerous and must be repaired.c) Disconnect the plug from the power source and/or the batt

7ENGLISH – When the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back