DeWalt DC413 Instruction Manual

DC413 Heavy-Duty 28V Cordless Cut-Off ToolDC415 Heavy-Duty 36V Cordless Cut-Off ToolOutil de tronçonnage sans fil robuste de 28 V DC413Outil de tronço

9EnglishGFKFIG. 3FASSEMBLY AND ADJUSTMENTSAttaching Side Handle DThe side handle (D) can be fitted to either side of the gear case in the threaded hol

10EnglishNOTE: If the gear case and motor housing become separated by more than 1/4" (6.35 mm), the tool must be serviced and re-assembled by a

11EnglishType 27 guard4-1/2" Grinding Wheelsunthreaded backing flangethreaded clamp nutType 27 hubbed wheelType 27 guardType 27 depressed center

12English4-1/2" Sanding Flap Discshubbed sanding flap discunthreaded backing flangenon-hubbed sanding flap discthreaded clamp nutrubber backing p

13EnglishCAUTION: If the guard cannot be tightened by the adjusting clamp, do not use the tool. To reduce the risk of personal injury, take the tool a

14English 2. Depress the spindle lock button and use a wrench to tighten the hub of the wheel. 3. Reverse the above procedure to remove the wheel.C

15Englishlimit the use of these wheels with a standard Type 27 guard to shallow cutting and notching (less than 1/2" in depth). The open side of

16English 5. To remove the wheel, grasp and turn the backing pad and sanding pad while depressing the spindle lock button.USING SANDING BACKING PADSCh

17EnglishCLEANING AND DISPOSAL 1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the duration of the sanding projec

18EnglishMounting and Using Cutting (Type 1) Wheels Cutting wheels include diamond wheels and abrasive discs. Abrasive cutting wheels for metal and co

1EnglishIF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT 1-800-4-DEWALT (1-800-433-9258) General Safety Rules

19English 5. To remove the wheel, grasp and turn while depressing the spindle lock button.USING CUTTING WHEELS WARNING: Do not use edge grinding/cutti

20EnglishThree Year Limited WarrantyDEWALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the da

DEWALT Industrial Tool Co., 701 Joppa Road, Baltimore, MD 21286(JUN07) Form No. 653787-00 DC413, DC415 Copyright © 2006, 2007 DEWAL

2Englishcaught in moving parts. Air vents often cover moving parts and should also be avoided.• Avoid accidental starting. Be sure switch is in the l

3EnglishWARNING: The grinding wheel or accessory may loosen during coast-down of the tool when shut off if rubber ring is missing or damaged. If grind

4English ...Class II Construction …/min ...revolutions or ...(double insulated) ...reciprocation per BPM

5English• Support large panels to minimize the risk of wheel pinching and kickback. Large panels tend to sag under their own weight. Support must be

6EnglishThe RBRC™ Seal The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the lithium ion battery (or battery pack) indicates that the

7Englishin a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.• Do not mount char

8Englishblink. The charger will no longer work and should be returned to an authorized service center or replaced.LEAVING THE BATTERY IN THE CHARGERTh