DeWalt DCG412-XE Service Manual download pdf (Page 19)

ENGLISH

• Make sure the disc or wheel rotates

in the direction of the arrows on the

accessory and the tool.

• Avoid overloading. Should the tool

become hot, let it run a few minutes

under no load condition to cool the

accessory. Do not touch accessories

before they have cooled. The discs

become very hot during use.

• Never work with the grinding cup

without a suitable protection guard in

place.

• Do not use the power tool with a cut-

off stand.

• Never use blotters together with

bonded abrasive products.

• Be aware, the wheel continues to

rotate after the tools is switched off.

Proper Hand Position (ﬁ g. 1, 6)

WARNING: To reduce the risk of

serious personal injury, ALWAYS use

proper hand position as shown.

WARNING: To reduce the risk of

serious personal injury, ALWAYS hold

securely in anticipation of a sudden

reaction.

Proper hand position requires one hand on the side

handle (e), with the other hand on the body of the

tool, as shown in figure 6.

Switch

WARNING: Before using the tool,

check that the handle is tightened

securely.

LOCK-OFF BUTTON AND TRIGGER SWITCH (FIG. 7)

Your cut-off tool is equipped with a lock-off

button(b).

To lock the trigger switch (a), press the lock-off

button as shown in figure 7. When the lock-off

button is depressed to the lock icon, the unit is

locked.

Always lock the trigger switch when carrying or

storing the tool to eliminate unintentional starting.

To unlock the trigger switch, press the lock-off

button (b). When the lock-off button is depressed

to the unlock icon, the unit is unlocked. The lock-off

button is colored red to indicate when the switch is

in its unlocked position.

Pull the trigger switch (a) to turn the motor ON.

Releasing the trigger switch turns the motor OFF.

inspecting and installing an accessory, position

yourself and bystanders away from the plane of

the rotating accessory and run the power tool

at maximum no-load speed for one minute.

Damaged accessories will normally break apart

during this test time.

OPERATION

Instructions for Use

WARNING: Always observe the safety

instructions and applicable regulations.

WARNING: To reduce the risk

of serious personal injury, turn

tool off and disconnect tool from

power source before making any

adjustments or removing/installing

attachments or accessories. Before

reconnecting the tool, depress and

release the trigger switch to ensure that

the tool is off.

WARNING:

• Ensure all materials to be ground or

cut are secured in place.

• Secure and support the workpiece.

Use clamps or a vice to hold and

support the workpiece to a stable

platform. It is important to clamp and

support the workpiece securely to

prevent movement of the workpiece

and loss of control. Movement of

the workpiece or loss of control may

create a hazard and cause personal

injury.

• Support panels or any oversized

workpiece to minimize the risk

of wheel pinching and kickback.

Large workpieces tend to sag under

their own weight. Supports must be

placed under the workpiece near the

line of cut and near the edge of the

workpiece on both sides of the wheel.

• Apply only a gentle pressure to the

tool. Do not exert side pressure on the

disc.

• Always wear regular working gloves

while operating this tool.

• The gear case becomes very hot

during use.

• Always install the guard and

appropriate disc or wheel. Do not use

excessively worn disc or wheel.

• Be sure the inner and outer flange are

mounted correctly.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

DeWalt DCG412-XE Service Manual Page 19

Comments to this Manuals

Related products and manuals for Power tools DeWalt DCG412-XE