DeWalt D25941 Service Manual download pdf (Page 13)

ENGLISH

Fitting and adjusting the side handle

(ﬁ g. 7)

The side handle (f) can be mounted on the front of

the machine to suit both RH- and LH-users.

WARNING: Always operate the

machine with the side handle properly

mounted.

1. Unscrew the side handle clamp knob (g).

2. Slide the side handle assembly onto the

machine locating the steel ring (h) in the

mounting area (X). The correct position of the

side handle is between head and middle of the

tube.

3. Adjust the side handle (f) to the desired angle.

4. Slide and rotate the side handle to the desired

position.

5. Lock the side handle in place by tightening the

clamp knob (g).

Instructions for use

WARNING:

s Always observe the safety instructions

and applicable regulations.

s Be aware of the location of pipework and

wiring.

s Apply a pressure of approx. 20 - 30 kg

to the tool. Excessive force does not

speed up chiselling but decreases tool

performance and may shorten tool life.

Switching on and off (ﬁ g. 1)

Switching on: set the on/off switch (a) to position 1.

Switching off: set the on/off switch (a) to position 0.

Demolition, chasing and channelling

(ﬁ g. 1)

1. Select the appropriate chisel, and clean and

grease its shank.

2. Insert the chisel and check whether it is properly

locked.

3. Set the desired impact energy level.

4. Fit and adjust the side handle (f) and make sure

it is firmly tightened.

5. Hold the tool at

both handles (b, f) and switch

on. The tool now runs in continuous operation.

6. Always switch off the tool when work is finished

and before unplugging.

Various types of chisels are available as an option.

Only D

EWALT recommended accessories should be

used with this product.

MAINTENANCE

Your DEWALT power tool has been designed to

operate over a long period of time with a minimum

of maintenance. Continuous satisfactory operation

depends upon proper tool care and regular cleaning

s This machine is not user-serviceable. Take the

tool to an authorised DEWALT repair agent after

approximately 100 hours of use. If problems

occur before this time contact an authorised

DEWALT repair agent.

Accessory maintenance (ﬁ g. 8)

Accessory maintenance at the right time guarantees

optimal results in application and a long and efficient

accessory life.

Grind the chisels on grinding discs. Refer to figure 8

for the appropriate angles of the following chisels:

spade-shaped chisel (i)

cold chisel (j)

pointed chisel (k)

U-shaped chisel (l)

hollow chisel (m)

mortar chisel (n)

toothed chisel (o)

WARNING: These chisels can be

reground only a limited number of

times. If in doubt, contact your dealer for

recommendations.

WARNING: Ensure that the cutting

edge does not show discolouration

caused by too much pressure. This may

impair the hardness of the accessory.

Lubrication

Your power tool requires no additional lubrication.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Comments to this Manuals

No comments

DeWalt D25941 Service Manual Page 13

Comments to this Manuals

Related products and manuals for Power tools DeWalt D25941