DeWalt DC415KL Use and Care Manual Page 9
- Page / 72
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
7
English
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not mount charger on wall or permanently affix charger
to any surface. The charger is intended to use on a flat, stable
surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug — have
them replaced immediately.
• Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to an
authorized service center.
• Do not disassemble charger; take it to an authorized service
center when service or repair is required. Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard household
electrical power (120 Volts). Do not attempt to use it on any
other voltage.
SAVE THESE INSTRUCTIONS
Charger
Your battery pack requires a 1 hour DEWALT charger. Be sure
to read all safety instructions before using your charger. Consult
the chart on the back of this manual for compatibility of chargers
and battery packs.
Charging Procedure
1. Plug the charger into an appropriate
outlet before inserting the battery
pack.
2. Insert the battery pack into the charger. The charger is equipped
with a three-light fuel gauge that will blink according to the state
of charge of the battery pack.
3. The completion of charge is indicated by the three red lights
remaining ON continuously. The pack is fully charged and may
be used at this time or left on the charger.
0% - 33% 1
st
light blinks
33% - 66% 1
st
light on, 2
nd
light blinks
66% - 99% 1
st
, 2
nd
lights on, 3
rd
light blinks
100% 1
st
, 2
nd
, 3
rd
lights on
Charger Diagnostics
This charger is designed to detect certain problems that can arise
with the battery packs or the charger. Problems are indicated by the
three red lights flashing together in different patterns.
PROBLEM POWER LINE
When the charger is used with some portable power sources
such as generators or sources that convert DC to AC, the charger
may temporarily suspend operation. The three red lights will flash
together with two fast blinks followed by a pause. This indicates
that the power source is out of limits.
BAD BATTERY
The charger can detect a weak or damaged battery. The three
red lights will flash together with rapid blinking. The battery will
no longer charge and should be returned to a service center or a
collection site for recycling.
BAD CHARGER
The charger will detect if it is not functioning properly. The three red
lights will flash together with one fast blink followed by a long
- EWALT • www.dewalt.com 1
- Operated Tools 3
- SAVE THESE INSTRUCTIONS 3
- Important Safety Instruction 7
- READ ALL INSTRUCTIONS 7
- The RBRC™ Seal 8
- Storage Recommendations 8
- Battery Chargers 8
- Charging Procedure 9
- Charger Diagnostics 9
- Important Charging Notes 10
- Pack (Fig. 1) 10
- Accessories 12
- Mounting Guard 12
- 4-1/2" Grinding Wheels 13
- Wire Wheels 13
- Sanding Discs 14
- 4-1/2" Cutting Wheels 14
- OPERATION 15
- Switch 15
- Mounting and Using Cutting 20
- (Type 1) Wheels 20
- Three Year Limited Warranty 22
- Patent Notifi cation 22
- EWALT, APPELEZ-NOUS 23
- EWALT (1-800 23
- Français 24
- LIRE TOUTES LES DIRECTIVES 28
- Le sceau SRPRC™ 29
- Recommandations de rangement 29
- CONSERVER CES DIRECTIVES 30
- Chargeur 30
- Procédure de charge 30
- Diagnostique de chargeur 31
- COMPOSANTS (fig. 2, 3) 32
- Meules de 4-1/2 po 34
- Brosses métalliques 34
- Accessoires 36
- FONCTIONNEMENT 37
- Détente 37
- ENTRETIEN 44
- Nettoyage 44
- Graissage 44
- Réparations 45
- Achat d’accessoires 45
- Garantie limitée de trois ans 45
- Avis de brevet 46
- LEA TODAS LAS INSTRUCCIONES 52
- EWALT y otros usuarios de 53
- EWALT. Otros tipos de 53
- EWALT. Otros usos 53
- CONSERVE ESTAS INSTRUCCIONES 54
- Cargador 54
- Procedimiento de carga 54
- Diagnósticos del cargador 55
- COMPONENTES (Fig. 2, 3) 56
- ENSAMBLADO Y AJUSTES 57
- Conexión del mango lateral 57
- Rotación de la caja 57
- Discos de esmerilar 58
- Discos de 58
- Accesorios 60
- Protector de montaje 60
- FUNCIONAMIENTO 61
- Interruptor 61
- (Tipo 1) 67
- MANTENIMIENTO 68
- Limpieza 68
- Lubricación 69
- Reparaciones 69
- Compra de accesorios 69
- Póliza de Garantía 70
- Notifi cación de 71
© 2020, manymanuals.com. All rights reserved. | 1.280 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals