DeWalt DW03101 Service Manual download pdf (Page 18)

Dewalt DW03101

18

EN

Message Codes

If the message Error does not disappear

after switching on the device repeatedly,

contact the dealer.

If the message InFo appears with a

number, press the Clear button and

observe the following instructions:

Care

• Clean the device with a damp, soft cloth.

• Never immerse the device in water.

• Never use aggressive cleaning agents

or solvents.

Warranty

Europe:

• 30 day no risk satisfaction guarantee

• One year free service

• One year full warranty

Detailed information are available on the

internet at www.2helpU.com.

North America:

• Three year limited warranty

• One year free service

• 90 day money back guarantee

Detailed information are available on the

internet at www.dewalt.com.

Safety Instructions

The person responsible for the instrument

must ensure that all users understand

these directions and adhere to them.

Areas of responsibility

Responsibilities of the manufacturer

of the original equipment:

Europe:

DEWALT

D-65510 Idstein, Germany

www.2helpU.com

www.dewalt.eu

North America:

DEWALT Industrial Tool Co.

Baltimore, MD21286, USA

For service call 1-800-4-DEWALT.

www.dewalt.com

The company above is responsible for

supplying the product, including the User

Manual in a completely safe condition.

The company above is not responsible for

third party accessories.

Responsibilities of the person in

charge of the instrument:

• To understand the safety instructions on

the product and the instructions in the

User Manual.

• To be familiar with local safety regula-

tions relating to accident prevention.

• Always prevent access to the product by

unauthorised personnel.

No. Cause Correction

156 Transverse tilt

greater than 10°

Hold the instrument

without any transverse

tilt.

162 Calibration mistake Make sure, the device

is placed on a abso-

lutely horizontal and flat

surface. Repeat the

calibration procedure. If

the mistake still occurs,

contact your dealer.

204 Calculation error Perform measurement

again.

252 Temperature too

high

Let device cool down.

253 Temperature too

low

Warm device up.

255 Received signal too

weak, measuring

time too long

Change target surface

(e.g. white paper).

256 Received signal too

high

Change target surface

(e.g. white paper).

257 Too much back-

ground light

Shadow target area.

258 Measurement

outside of meas-

uring range

Correct range.

260 Laser beam inter-

rupted

Repeat measurement.

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments