DeWalt DW746 User Manual download pdf (Page 34)

Equipment Needed:

The following pieces of equipment are needed to properly align the saw.

Description Part Number Qty

C-Clamp with 5/16” shank 233802-00 1

Dial Indicator 233802-01 1

Holder with 1/4” shank 233802-02 1

Clamp with holes for 1/4” and 5/16” shanks 233802-03 1

Assembly:

1. In the indicator box there is a small piece of paper with diagrams on both sides.

Use these diagrams as reference as you continue with this section.

2. In the dial indicator box you will find two tolerance hands. They simply snap

onto the face of the indicator. Also in the box you will find a bezel clamp and

thumb screw.

3. In the top of the indicator there is a small Phillips head screw. Remove this screw

and replace it with the bezel clamp, and thumb screw.

4. Follow the diagrams below to attach the indicator to the C-Clamp.

How to read the indicator :

Each mark on the indicator face is .001”. The total travel for the indicator pointer is 1

The outer black ring rotates so that you can zero the indicator. The bezel clamp will

prevent the outer ring from rotating.

BLADE ALIGNMENT:

EUROPEAN SERVICE SUPPORT GROUP

SERVICE DATA BULLETIN

Subject : Alignment Procedures Page 1 of 5

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 60 61

No comments

DeWalt DW746 User Manual Page 34