DeWalt D55275 Instruction Manual download pdf (Page 10)

English

2. Turn knob clockwise to increase regulated

pressure and counter clockwise to

decrease regulated pressure.

3. When desired pressure is shown on the

regulated pressure gage push knob in to

lock.

INSTALLING HOSES

WARNING: Firmly grasp hose in hand

when installing or disconnecting to prevent

hose whip.

1. Ensure regulated pressure gage reads 0 PSI.

2. Grasp hose in hand at coupler location.

3. Pull back collar on female quick connect coupler (M) located on

compressor.

4. Push male connector into female connector.

5. Release female connector

6. Grasp hose and pull to ensure couplers are seated

7. Adjust regulator to desired pressure.

DISCONNECTING HOSES

WARNING: Firmly grasp hose in hand when installing or

disconnecting to prevent hose whip.

1. Ensure regulated pressure gage reads 0 PSI.

2. Grasp hose in hand at coupler location

3. Pull back collar on female quick connect coupler located on

compressor.

4. Pull male connector out of female connector.

5. Release female connector

DRAINING TANKS

WARNING: Tanks contain high pressure air. Keep face and other

body parts away from outlet of drain. Use safety glasses when draining

as debris can be kicked up into face. Use ear protection as air flow

noise is loud when draining.

NOTE: All compressed air systems generate condensate that

accumulates in any drain point (e.g. tanks, filter, aftercoolers, dryers).

This condensate contains lubricating oil and/or substances which may

be regulated and must be disposed of in accordance with local, state,

and federal laws and regulations.

1. Ensure ON/OFF switch is in the OFF position.

2. Move compressor into an inclined position so drain valve(s) are at

the lowest point (this will assist in removing moisture, dirt, etc. from

tanks)

3. Place a suitable container under the drains to catch discharge.

4. Grasp black lever on one drain valve.

5. Slowly rotate lever so as to gradually bleed air from tank.

6. Grasp black lever on other drain valve and rotate to approximately

the same position as the first. (For twin tank units)

7. When tank pressure gauge reads 10 psi, rotate valve(s) to the fully

open position.

8. Close drain valve(s) when finished.

Preparation For Use

INITIAL SET-UP:

Read safety instructions before setting-up air compressor.

CAUTION: Do not operate without lubricant or with inadequate

lubricant. D

EWALT is not responsible for compressor failure caused by

inadequate lubrication.

Compatibility

Air tools and accessories that are run off the compressor must be

compatible with petroleum based products. If you suspect that a

material is not compatible with petroleum products, an air line filter for

removal of moisture and oil vapor in compressed air is required.

NOTE: Always use an air line filter to remove moisture and oil vapor

when spraying paint.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

DeWalt D55275 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Air compressors DeWalt D55275