DeWalt D2002M Instruction Manual download pdf (Page 12)

English

OPERATING PROCEDURES

WARNING: Do not operate this unit until you read and understand

this instruction manual for safety, operation and maintenance

instructions.

Start-up (Fig. 1)

1. Follow Pre-Start Checklist under Preparation for Use.

2. Move the On/Off switch to the ON position and allow tank pres-

sure to build. Motor will stop when tank pressure reaches

cut-out pressure.

CAUTION: Risk of unsafe operation. Compressed air from the

unit may contain wa ter condensation. Do not spray un fil tered air

at an item that could be damaged by moisture. Some air op er ated

tools or de vic es may require filtered air. Read the in struc tions for

the air tool or device.

3. Adjust regulator (D) to desired setting. See Regulator under

Features.

Shut-down (Fig. 1)

1. Move On/Off switch (A) is in the OFF position. NOTE: If finished

using compressor, follow Steps 2–6.

NOTE: When the unit has been turned off, it is normal to hear a

short hiss of air being released.

2. Turn regulator knob (D) counterclockwise until fully closed. Ensure

regulated pressure gauge reads 0 psi.

3. Remove hose and accessory.

NOTE:

Always turn off and unplug unit when not in use.

WARNING: Risk of unsafe operation. Firmly grasp air hose in hand

when installing or disconnecting to prevent hose whip.

4. Drain the air tank,

see Draining Air Tank under Maintenance

Ensure air tank pressure gauge reads 0 psi.

WARNING: Risk of bursting. Drain air tank daily. Water will con-

dense in air tank. If not drained, water will corrode and weaken the

air tank causing a risk of air tank rupture.

5. Allow the compressor to cool down.

6. Wipe air compressor clean and store in a safe, non-freezing area.

MAINTENANCE

The following procedures must be followed when maintenance or

service is performed on the air compressor.

1. Ensure On/Off switch is in the OFF position.

2. Remove air compressor plug from outlet.

3. Drain air tank.

4. Allow air compressor to cool down before starting service.

NOTE: All compressed air systems contain maintenance parts (e.g.,

oil, filters, separators) that are periodically replaced. These used parts

may contain substances that are regulated and must be disposed of in

accordance with local, state, and federal laws and regulations.

NOTE: Take note of the positions and locations of parts during

disassembly to make reassembly easier.

NOTE: Any service operations not included in this section should

be performed by a D

WALT factory service center or a D

WALT

authorized service center.

Maintenance Chart

Procedure Before Each

Use

Daily or after

each use

See tank

warning label

Check safety valve

Drain air tank

Remove tank from

service

1- For more information, call 1-800-4-D

WALT (1-800-433-9258)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Comments to this Manuals

No comments

DeWalt D2002M Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Air compressors DeWalt D2002M