DeWalt DWS778 Service Manual

www..euDWS778

ENGLISH8 • Do not use any abrasive or diamond discs. • Use only saw blades where the marked speed is at least equal to the speed marked on the saw

ENGLISH9 i. Sliding fence lock lever (fig. 11) j. Fixed table k. Kerf plate l. Mitre arm m. Mitre latch n. Rotating table/mitre arm o. Mitre

ENGLISH10IMPORTANT: The saw head (y) must be in its highest position to install a new blade. 1. To raise the saw head (y) to its highest position, pu

ENGLISH11OPERATIONInstructions for Use WARNING: Always observe the safety instructions and applicable regulations. WARNING: To reduce the risk

ENGLISH12Cutting Non-Ferrous MetalsWhen cutting non-ferrous metals, the machine is only to be used to perform vertical straight and mitre cross-cuts i

ENGLISH13 WARNING: If the saw blade is worn, replace it with a new sharp blade.LubricationYour power tool requires no additional lubrication. Clea

ENGLISH14GUARANTEEDEWALT is confident of the quality of its products and offers an outstanding guarantee for professional users of the product. This g

2 English (original instructions) 6Copyright DEWALT

Belgique et Black & Decker - DEWALT Dutch Tel: 32 70 220 063 Fax: 32 70 225 585Luxembourg Nieuwlandlaan 7, IZ Aarschot B156 French Tel: 32

1Figure 1Figure 2v0504530abcdghnklmefoqryuutusvwzddxbbffgghhyiijaattv vcc

20504530Figure 3Figure 5Figure 6Figure 4Figure 7Figure 8Figure 9Figure 10emmkklluufDE7023ruunfeheegjjbii

301530455001530455005045300504530Figure 11 Figure 12 Figure 14Figure 13Figure 16iqFigure 15mlnonnpoohqoohtqqssurrppppccttz

4015304550015304550Figure 17Figure 21Figure 18Figure 22Figure 200504530Figure 1905045300504530

5Figure 24Figure 23ffFigure 25ffffff

ENGLISH6CROSS-CUT MITRE SAWDWS778Congratulations!You have chosen a DEWALT tool. Years of experience, thorough product development and innovation make

ENGLISH7Read all these instructions before attempting to operate this product and save these instructions. SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTU